Hello guys, my name is Maxwell and welcome to the Maxbubbles RU-vid channel. Here, you will find household appliances, and what not. I do take requests. Tell me what you want me to film and what video you want me to film of whatever it is you want me to film and I will make that happen.
Here are the appliances you will see on my channel. Bosch 500 series SHPM65Z55N/01FD010504588 (our dishwasher) Whirlpool WFW92HEFC0 front load washer (our washer) Whirlpool WED92HEFC1 dryer (our dryer) LG Washtower WKE100HWA laundry center (cousin’s laundry center) You will probably see more in the future.
@@edwardwaits47 Take the top panel off. There are 3 screws on the back of the machine. Unscrew those, then push back, and it should come off. On the door lock, there should be a tab you can pull, and the door should pop open. Good luck.
@@maxbubbles6009 I borrowed some "star" driver set and none of them fit. they were labeled T1 T2 etc... but not all #'s were available in his set and i am not sure I am on the right track here? Can you confirm the driver head type and its size so I can go buy one?
The food in my fridge is freezing. Unfortunately, the display on my fridge is not working, therefore I do not know the current temperature settings. My thought was to reset the fridge to give me a "starting point" temperature, and adjust it down in 2-degree steps from there. Does the fridge always reset to a specific temperature setting? If so, could somebody please tell me what they are (for freezer and fridge)? Thanks in advance!
I absolutely hate this washer it always rinses and hot I don't know why I've tried to do the settings several times changing it to cold wash but it always rinses and hot. Just a stupidest setup it will not unlock the door for 5 minutes after the cycle. I bought it at Costco if it wasn't such a pain in the ass to take back I would have took it back a year ago
Such nostalgia I remember in 2019 when we moved to Wheaton IL we had a whirlpool washer and dryer from 2015 and they made the exact same sounds, but sadly it got replaced with an LG in 2022
@@jamesobriant1417 on this machine, the delicates cycle barely uses any water, and I don’t think it’s made for large loads, and this machine doesn’t have a bulky cycle.
I used to have the WM2455HG which is the gray version of this machine. Yes, that machine was one of the weirdest washers i've ever seen. My washer also did the thing where it would drain/fill at the same time. I always thought my machine just had some weird defect, but I guess this video proved me wrong. I have since replaced it with a WM4000HWA which has been MUCH better. Awesome video, and thanks for sharing!
@@vivianholder8775 This machine doesn’t have a soak option. Your best bet is to use the pre-wash option. You could also soak the load in a bucket or a bathtub, then put the load in the washer soaking wet.
This might be a wire connection failure because after the machine Initially powers up it starts gathering data from other components like the load & go, and if it can't do that it sometimes gives up like it did here. If you had an entire board failure, the machine wouldn't power up at all unless you entered diagnostic mode Enter diagnostic mode and see if you get an F06-E02 code or similar that usually corresponds to the control board. Good luck Max!