What's up guys our names are Joseph and Johnny Kamendy and we are from St. Catharines, Ontario. We've grown up fishing the Niagara Region and even down in Juno Beach, Florida and have gained a huge passion for being on the water and sharing what we love. We are constantly learning new techniques and gaining insights along the way and hopefully you can join us for the ride and have a good time! *As an Amazon Associate we earn from qualifying purchases*
Thanks again for the videos. I was able to make one in 1 hour then a other 1 hour to adjust I cheated a bit used a 1/2" tube as a sleeve as I had more complex bend less space. Once I got two sides bent I brought them together inside the sleeve and welded it. Ended up with a 3/8 heim joint it was lower profile with gease fitting. Thank you again
I just ran into this same exact problem and this video was a huge help, thank you so much for posting this! So hard to find anything related to this issue online with so many different things it could be. I just ordered the same new switch assy and will post my results tomorrow. Thanks again!
Yes I like to make sure we are headed in a straight line while letting out my lines to make sure I don’t get any tangles especially with leadcore and dipsys
My bad was a bit rushed but more than happy to answer it in the comments. Green spoons took most of the hits and as I said about 50ft down in 100-130fow trolling about 2.3-2.5mph
Honestly just preference based on the boat we have and setup we run. We know guys who do use them for riggers but find rocket launchers better for our boat
When cutting threads use some oil and start the clockwise cut go full turn then back up 1/4 turn this drops the chips out of threads. continue full turns back up 1/4 turn then proceed process until completed. You can actually feel this helping while cutting threads
I wish you would’ve shown a little more footage of the fish you pulled in to make this video more interesting. What a shame you started out pretty good. Like for example what fish were these? Name? About how much did each weigh ? AGood start at video presentation but you’ve got a long way to go to make them more entertaining it’s not about you it’s about us the viewers.
I recently visited your RU-vid channel and was impressed by its aesthetics. However, upon further exploration, I noticed a few areas that could benefit from improvement. One of the main aspects that caught my attention was the lack of optimization in terms of SEO, ranking tags, and tag volume. These aspects have not been adequately addressed on your channel. I'm Arafat Amin, a Freelancer with over 2 years of experience in RU-vid video SEO. I specialize in enhancing the visibility and discoverability of RU-vid content through effective optimization techniques. I would be delighted to assist you in optimizing your RU-vid videos and improving your overall channel performance.
@@JKFishingYt ah gotcha. I’m coming down the for acouple weeks. What do people usually catch that time? I’m also interested in fishing for sharks off the beach.
Usually bluefish and Spanish mackeral are in thick but like I said that is heavily dependent on the winds and water temps. For sharks, there should be many blacktips in close that will follow the fish mentioned above. If there are blues and Macks, then there are definitely sharks
Some solid catches you guys had. Just switched lakes up and now up at lake ontario im excited to catch some salmon on the boat with the family. From your video and others ill definitely have to upgrade my rods and reel from the okuma cold water 2 to the 3 series with some different line setups. Fishing just lake trout in pa you can get away with smaller gear. Keep the videos coming. New sub for sure.
Great little sharpener. But I don't buy anything from Amazon if I can find it anywhere else. I just ain't giving that company any of my money if I can help it. I try to shop with local business or either White Mountain Knives. Great small business to buy from.
