One of the bulbs on my climate control failed. From the research I’ve done it’s my understanding that those bulbs are soldered directly to the board, and fully functional replacements for the entire unit are few and far between. I haven’t seen inside the unit itself, do you know whether or not it’s true you can’t just replace the bulbs?

Now I don't need to get a Orfice Tube Divining Rod .

Is there a way to know if the line has a leak or the bag????

Thanks, I was about to climb under this thing. I`m glad GM engineers actually did something right and made access to it from inside.

i m facing same issue in kia niro hybrid 2017 no leaking no misfiring no indication of failure on speed o meter but in the morning in cold weather it creates a white smoke i have to refill coolant every second day and every 40 miles i have to refill whole bottle of coolant to maximum. its great headache

Is this the same at an 18’ Malibu with the 1.5l ecotech?

Everything goes pretty smoothly as far as changing the coils and the plugs, but why am I having such a difficult time trying to get the spot plug boot back on the spot plug on the lower part of the engine on a 6.2

How did you get the little yellowish plastic clip off ?

Hi MT 406 Mechanics, I am having the same problem now with my 2000 Dodge Ram 1500, 5.2 L/318 C.I. Since what you have here as replacement parts for the part # 05019015AA, I presume using these will work on my truck also? Thank you! My truck is currently down at my mechanic's shop now and all he has told me is that the part # 05019015AA is not made anymore and has put it on me to maybe locate it somewhere. Thanks,again -Mark

Thank you for the quick and easy tutorial! 5 minute fix. It took me longer to figure out the ignition wouldn’t work afterwards because I had the wrong keys.

Good job my friend

One of the best instructional videos on You Tube,Thank You,you should have been an Auto Mecanics Teacher,you would have made a good one,clear and easy to understand instruction!

My car would still start.. it would just stall and sometimes would crank a few times before it would start.. after three years. I’m getting something like this happening again.. acting like there’s water in the fuel, it spits and sputters and stalls. Then I started up again. It puffed out some smoke.

Is this the part that makes the Traction Control randomly kick in automatically while driving 60 on the hwy?

Screw this part, and screw GM for telling me they won't replace it without replacing the entire intake manifold. THANK YOU EBAY SELLER for having the part even though it's just going to fail again smh..guess I'll be doing what everyone else does and drilling into it and bolting it down myself.

Thanks

Thanks

Have a 2010 malibu in the shop right now. I believe its the torque sensor just couldnt figure out how to get to it. Thanks for the help!

Lo limpié esta mañana ya no se a apagado gracias por el consejo 😊

What are the two seals that come with the impeller for?

Thank you so much for the video, you save me probably four hours. 👍

Couldn't you find any nastier music

Very helpful video- thanks for taking time to post it.

Did anyone use pliers to get the cable back on the balls? I’m having a hard time just using my hand.

I did this repair but despite the lengthy hose it ultimately kinked causing problems -beware! Better to install a prebent piece…

99 Silverado just put new air injection pump it didnt pass smog 4 times how long does it take to kick in my tags are due in couple weeks.been driving all over the place macanic told me

The new switch from Napa fixed the wiper issue (they were stuck on intermittent). However, now the windshield fluid button is not working. You dont even hear the pump trying to run. Any thoughts?

BEST DIAGNOSTIC PROSES ,,, THANKS FOR YOUR TIME !!!!!

My actuator just went bad. Im now in 3 wheel drive. The 2004 sucks water through the vaccuum into the hubs. Get a free wet vac with your truck.

Would this be the same for diesel engine with dual batteries?

Does the coolent leak happen on cold engine only?

Great video. Thank you.

1

On my F150, a 2007, it was the actual module in the motor. When Ford wipers ghost run, its almost always the module in the motor.

Just performed on my 2017 Niro with 167,000+ miles. No visible leaks or clues like wet bumper, but was the issue for sure. Exhaust smelling like hot coolant and steam cloud looking. Thanks for the post!!!

That is the best dam video I have seen on how to instal a cartridge block heater on the Toyota 2.5 engines! I have been mistakenly looking at the back of the engine against the fire wall!

thank you very much for the help. super easy maintenance. saved me money!

I have a question, I have a 2018 Malibu, with the “Engine Reduce Power” codes P16A0, P16A1 and P16A2, a shop made me change the throttle body twice and i keep getting the same code over and over, any suggestions??????

Why was the office changed? What kind of pressures were you getting to tell if it needs to be changed? Was it high pressures because its clogged?

Hello, I follow your channel closely. I need help with something. I have a 2003 V8 Vogue brand Range Rover. The right door lock is disabled. How can I activate it again? Where is the socket or the fuse has been disabled knowingly and willingly. can you help me

Great your tube, thanks

The OLD one looked fine, how do tou tell if its shot???

ive got a question what happens if i have fix it but the code still shows

These sensors are faulty as hell and pieces of crap no matter which one you buy they will always leak out of the connection terminal when least expected dumping all of your 5 quarts out without giving any warning whatsoever

Worked for me. Commenting for engagement. Klein 11in1 screwdriver has the small torx screw size

Thank you! Spot on pin checks and got it running after quick run to part store so no need to tow it!!!! 👍👍👍

Just a heads up DO NOT BUY A Dorman 949-728 as a replacement bag!!!! It is not the correct bag!!! I suggest going with a Arnott Part #A-3233. You dont have to worry about no special airing up sequence or manipulating the bag while its airing up or anything. Simply clip it into the top push the air line into the quick disconnect, put your tire back on and lower the car down and start it up and it will air up perfectly no popped ring nothing.

So i have an oil pressure light on and i believe its the switch. 05 same as the one in the video. Ive been monitoring for a week. No change in oil levels, only a light that comes on. I just bought 4 new tites. Im about to get a oil change. Will this only cause an oil pressure reading error or will it cause more problems if i take it on a road trip and fix when i get back? Im probably gonna fix it before i go but im just interested mainly.

Thank you!!!!! This has been annoying me like crazy

How much is the part