There’s nothing wrong the clunk you heard is the electronic clutch engaging the compressor and the increase in engine rpm is normal because the compressor put a slight load on the engine so the engine works slightly harder when the ac is on.
METHOD ONE (Most difficult procedure):"]______________________________________________ 1. Confirm that accelerator pedal is fully released, turn ignition switch “ON” (without starting vehicle) and wait 3 seconds. 2. Repeat the following steps (2a and 2b) procedures quickly five times within 5 seconds. 2-a. Fully depress the accelerator pedal (HARD).2-b. Fully release the accelerator pedal. 3. Wait 7 seconds, fully depress the accelerator pedal and keep it for approximately 10 seconds until SERVICE ENGINE SOON starts blinking. 4. Fully release the accelerator pedal (while SERVICE ENGINE SOON is still blinking). 5. Wait about 10 seconds. 6. Fully depress the accelerator pedal and keep it for more than 10 seconds. 7. Fully release the accelerator pedal (The SERVICE ENGINE SOON light will continue to blink). 8. Turn ignition switch to “OFF” position and now you can start the vehicle. The SERVICE ENGINE SOON light should be gone. If the SERVICE ENGINE SOON light continues to remain ON, repeat the above steps. Timing is EXTREMELY critical to resetting the ECU. ______________________________________________ METHOD TWO (Medium difficulty):"]______________________________________________ 1. Turn ignition "ON" (without starting vehicle), count to 3 seconds. 2. Depress/Release accelerator pedal 5 times...hard and fast. 3. Count to 10 seconds (not 7!) and fully depress accelerator pedal. 4. Count to 12 seconds (SERVICE ENGINE SOON should be blinking), release accelerator pedal. 5. Count to 10 seconds, depress accelerator pedal. 6. Count to 10 seconds, release accelerator pedal. 7. Turn off ignition, then start engine. Done! ______________________________________________ METHOD THREE (Extremely Simple):"]______________________________________________ 1. Remove negative battery cable from vehicle battery. 2. Allow vehicle to sit for at least 24 hours with negative cable disconnected. 3. After 24 hours, reconnect negative cable to battery. Good Luck!
No they wont the repo man dont have possession of the vehicle until it’s secured to the truck and no1 is in it. If some1 is in it they cant take it or stop the person legally
