This channel is about a husband and wife lawncare entrepreneurship running a business as a couple. We will share our accomplishments and would love to hear your accomplishments by joining us on our live streams. As part of a lawn care community that is helping others succeed with our tips on what works and what doesn't. Many others in the lawn care community would love to hear your opinion. Share tips on our live streams. We also do repair videos on our equipment along with sharing videos of our sign shop.
Nice blend job, Good spray passes, Do yourself a favor and get under and look on the backside... open the rubber plugs and you really should spray a rust prevent coating inside those rockers, you are luck the rust isn't through yet.... it usually starts from the back inside and works outwards. I know you know your stuff.... just wanted to remind you. I have seen so many bad rockers and replaced so many
I would like to get one of these for my Gravely ZT HD, but was wondering how difficult it is to remove this in the fall when I want to install my bagger system?
Ok, That’s why you guys cover every inch of your skin, you’re afraid to get dirty. 😂 Enjoy the heat! That’s nuts. I’d be doing it naked if it were legal. Once you master the job you will see that you don’t have to work hard or get excessively dirty doing lawns. All the best!
You could set up the rear truss as a a hinge and thread your pull line around a pulley on it so once the canoue came forward and hit an end stop, it would raise the tail of the canoe so the canoe wnds up parallel to the truck bed and you won't have the front of the canoe sticking up so far in the air where it could hit low branches or bridges or anything.
Great knowledge and how to video on the hydro fluid but I will add that motor oil and hydronic oil are not supposed to be swapped. They have different chemical properties and can cause damage
Parts aren't as hard to find as you would think. I was able to get all of the parts I needed through my local Honda dealer. Ebay and Amazon have many aftermarket parts also.
what size tire did you do - my cruiser has 15 and 16 in wheels... and apparently it doesn't do 15's? due to the top ring??? any way you figure to work around that?
I’m literally doing the same engine swap. I was fortunate enough to have a scag tiger cub given to me with a blown engine. I have the same Kohler engine but a 25hp. Watched you other video of doing the job. Hopefully will have it finished up by tomorrow. In hope of all of this, I’ll have my own mower again instead of borrowing one from friends and family. Now to figure out how you wired the starter solenoid, have a good idea based on your video. Just been better of if I had a picture. Oh well, I’ll figure it out.
Everyone screws up at least once in their life. Love the demo on how NOT to maneuver a Gravely in a crowded garage. (Love the Harley, too.) My comment/question is why not use an oil extractor? I just got a manual pump-it-yourself version at Northern Tools for $20.
A true pro. Noticed the struggle with the roof protective film . My 10 x 12 will get here soon but the roof planks are undulated .Hopefully one of my sons will give me a hand . Thanks for posting.
Great video, i have same machine. It started last season 2023 steering levers where getting further apart. Then reverse was getting worse. I adjusted the rod on right side and was better forward but worse in reverse. Saw your video and had same problem. tightened two bolts readjusted the rod back to where it should be. THANK YOU!!!!!!!!!!!
