Was thinking hard about going there instead of the DMZ at the other end of Korea and the Dora observatory cause of its remote and quietness and the East Sea/Sea of Japan at the end of it. What is the backstory as to why and how that Korean tourist got shot back in 2008?
I don’t know but it sounds unlikely that a 53 yr old woman was making a run to N Korea early in the morning. Witnesses say she was out walking and viewing the sunrise. She also had to cross a 3m fence to get into the “no go” zone.
I cannot seem to “repeat the same procedure” on the tank side panel. The sliding tank lock and the tank valve do not allow me to push the panel forward like I did on the side opposite of the tank. Do you have any extra tips or videos on removing the side panel on the tank side?
Thank you for the great video and response. I feel confident that my GE Cafe has the same issue. Just need to prove it like you described and then fix it. Thanks again.
Not really. That sensor is also part of the climate control housing. The recommended procedure is to swap over everything to new climate control housing.
Great description, thanks you very much :) Any tips for what to check when AC is working fine and cold air is coming 16:26 on passenger side and in the rear but not in the front and at the driver’s seat (just air)? It’s a 2017 Ford Transit “Tourneo”.
Appreciate this upload. Able to gather what I needed prior. Purchased $14 Amazon RLB-Hilon seller cover. I used a wooden flat spatula to pry the bottom mirror off. Easy to follow process.
I'm doing this upgrade right now on my son's Oset 12,5r...from 2x SLA lead acid 12v 10Ah batteries (in series, so 24v total) to 2x LiPo 6s 7000Ah (in parallel, so 14Ah in total). I will use exactly your configuration with the harness (to use also SLA batteries if needed), XT90 connectors and 10awg wire. Thanks a lot for your guide.
I did my own test without a pressure sprayer. I used Mold Armor concrete formula and I actually waited 10 to 30 minutes and it worked a lot better than LAs Totally Awesome that I sprayed at 5-1 concentration and over a period of 35 minutes scrubbed the surface repeatedly with a brush broom in 90 degree directions 6 to 10 times. LAs doesn't seem to be able to eat away at the mold like Mold Armor does.
So it won’t brew coffee either? That would help narrow down if water is coming into the fridge vs being an electrical panel/button issue on the fridge.
I’ve got a 2018 250. Air works pretty good upon start up but after an hour or so, air slows to a trickle out the vents. Replaced the blower motor. But nothings changed. Any ideas?
@@MTBPlanB I honestly haven’t tried heat yet. But I may have commented too soon in the video. After watching to the end, I think it may be the evaporator? The AC does make a louder hum from the engine bay when it’s on too. Like the fan but louder than normal
I have an 8E1 error code. However I replaced the vibration sensor and I’m still getting an 8E1 error code. I’m about to lose my mind!!! It’s been down for 5 months now. 🥴😵💫🤦🏻♀️ 🤯🤬😭 I replace the bearings and seal, the spider arm is in great condition I replaced the shocks, and now I’m still getting the 8E1 error code. Please if anyone can help I would be so grateful! 😊 Thank you Samsung WF56H9100ag/a2-00
It eventually will fall into your gas tank and likely cause another problem and you’ll have to fish it out. I just replaced it with an external check valve.
Going from 235/65/16 to 245/75/16 @ 70mph on speedometer your actual speed will be 76mph. I believe ford locked out the calibration in the software to make the change in 2014 for transits. So i went with 225/75r16 and its 3mph off at 70mph (73mph actual)