Russell Hobbs od 50 lat jest synonimem życia w kuchni. Jego dumnie eksponowane produkty, są znane w milionach domów. Urządzenia kuchenne marki Russell Hobbs mają reputację ponadczasowych i stylowych. Wszystkie artykuły - od czajników i tosterów po ekspresy do kawy, produkty do gotowania, pieczenia i przygotowywania żywności -- zostały zaprojektowane z myślą o kliencie, aby zapewnić jak najlepsze wyniki pracy w kuchni.
Jestem bardzo niezadowolony dopiero co kupiłem ten gówniany produkt i nie daje pary. Nagrzewa się daje ten przycisk blokady do góry i naciskam . NIc to nie daje , zero pary jak mozna komus wadliwy sprzęt sprzedać
Never buy a russel hobbs coffee maker.. it makes anoying noise when its don makiking coffee. It goes tick.. tick.. tick. For minutes. Caused by the heat or steam So annoying when you want to enjoy a silent cup of coffee in the morning. This is the most annoying machine ever.. never a russel hobbs again
after buying a new filter and trying to install it for over 2 days I give up - going to buy another kettle but next time make sure its NOT A RUSSEL HOBBS KETTLE!!
Gdzie i za ile mogę dokupić do tego modelu końcówki metalowe ? Niestety te wasze innowacje spiralno- plastikowe są beznadziejne , wyrzucają z misy mieszane produkty np. krem do tortu, ciasto o gęstrzej konsystencji niż ciasto naleśnikowe 🤷♀️
The first thing to understand is THE FILTER IS INSERTED BACKWARDS. IT FACES BACKWARDS NOT THE FRONT WAY WE’VE BEEN TRYING TO FORCE IT. Note: take a look at the filter you’d notice two round pins on the opposite end of the filter. There’s also a bottom clip you use to insert. Those pointy parts come would face the nozzle/spout (the part where you pour from) of the kettle not the other way. (Made the mistake too lol) 1. Hold the pointy big clip at the top with ya fingers. 2. Make sure the front of the filter is facing the Pole when inserted into kettle. 3.Place that bottom clip and push down to insert the filter.
OKAY GUYS I MANAGED TO PUT THE LITTLE FILTER BACK!! No thanks to this video 😒 anyway, just hold it so the longer, flat end is at the top and the curved surface is facing the inside centre of the kettle. Okay now there’s a little black bar near the top of the kettle where the spout is on the inside. Look at the little slot flaps on the filter thing and there are two sticking out flaps on the bar thing. Just align the net with the bar and slot it in and it should be fixed. I tried explaining that as best as I can? Hope it works! 😊 Edit: It's come off again lol so I went back to this vid to see how I did it last time and I want to mention that when you're aligning it, tilt the bottom of the filter forward. It should cover all of the inside of the spout :)
