The legacy of this channel is to help junior engineers by teaching them the mysteries behind computer-aided engineering. This channel is dedicated to the finite element method, which encompasses a wide range of mechanical, thermal, and chemical properties and behaviors while examining various manufacturing methods.
Good question, you have two option, first, create a block in the sam size as your helmet, then trim it in solidworks, or use nTopology software to optimize the solid type of your helmet
It is an excellent contribution, it's just that the video resolution is very low. Thank you so much for this contribution, there is not much information on the internet about this wonderful software. Please continue teaching us about Procast, really, thank you so much.
Alejandro, as i know, the resolution depends on your internet speed, because for me and some of my friends (to check the problem for you) the resolution is ok. and thanks for the motivation, ill share more tutorials.
Sure, thanks for your compliment, please share the geometry of your model so i do the simulation on your model, you can send it through linkedin or email to me
Dear sir, Thanks for the vedio. Am doing research in Lattice structure. The value of your simulated unit cell shows stress of 797 MPa. As for my knowledge the lattice cell will have not more than 200 MPa max. Can you sort this. And also one help. Can you simulated with the multiple unit cells and put videos. It will show plateau region as well.
the strength depend on the structure and material, so you MAY reach high strengths in you lattices based on the materials and the criteria you are using for the results, sure i will do the simulation for the whole structure asap, what lattice unit cell you are working on ?
Sir after designing this structure , I took the stl file to cura slicing software and it says due to mesh problem my model cannot be printed accurately. How do I mesh this model?
The Problem is that you need to combine all patterned unit-cells to one solid, how to do it? go to your insert menu, features, and use combine command, chose all of your lattices from the body tree, and done, the structure is now printable, if you have any problems contact me on LinkedIn, and don't forget to share the printed structure with me ;)
Please Im a little beginner and need to simulate a composite material , should I work on ansys student or Abaqus Learning and if u can make a tutorial abt composite materials simulation
Sure, i wanted to post about crashing of aluminum can for the next Abaqus video, but i will share about composite mateirals and i hope it helps you on your project. i always suggest abaqus for mechanical simulations but you can use both of them. i will share the CAE about composite asap
