Thank you. if you tell me exactly the problem, I can help.🙂

@@CallutLathe good morning the proplem that l am stuck with the measuring for the cylinder diametr and the piston diameter and strok lenth for force about ten to twenty ton Also the power motor how many k.w and i have a good hydrulic gear pump(36.5 xv)

two thousand fifty, sorry two hundred fifty mıllon 😂

i think it was an average pressure of 20 bar.and this is the smallest lathe I have😅

@@CallutLathe all right, thank you😬

this cat is actually a stray cat. and there are a lot of stray dogs where we are. we can say that the cat is safer here. and because he loves me so much, always there for me during my working hours.there's no need to worry.😻

they will use them for the ship. actually, it's even small. 🙂

dude, the work is still going on.i'm sorry right now. and I'll do my best to finish the job soon and make a video.

Thank you 🙂.

the pipes come pre-honed. I do not do any other operations except cleaning into the pipe. you know that there should be no dirt in the hydraulic installation.

@@CallutLathe ok thank you for your response...

I'm glad you like it.

Coming soon. Maybe tomorrow 🙂

in fact, the logic of processing materials proceeds in the same way. it sounds logical to write the coding according to this processing logic.

china made lathe.

Yes it is 😅

tube is already honed

I did surface hardening. that's why I applied a lot of heat :)

it produced a pressure of 20 bar. it is not possible for us to capture more pressure with this manufacturing method.

hey, this pipe is pretty thick. vice does not hurt.

i usually buy it. I make it special myself when it's not in the measurements I need.

I'm still making improvements to the product. you can see it on an rc hydraulic crane soon.the pump you made is also very successful.😊

i'm not selling. but a more professional production can be made and tried.

there's no need to worry. this weld was used for the video. we do tig welding under normal circumstances.

and what you say is true. it is more correct to perform the threading process after welding.

I bought the remaining materials from scrap, except for the piston rod. it didn't cost me much.

Öncelikle teşekkür ederim. Triger kayış kasnağı hakkında bir bilgiye sahip değilim. Yapmış olduğum v kayış kasnağı da bir elektrik motoruna ait, ve tecrübelerim dahilinde yaptım. Yardımcı olmak isterdim ama bilgim yok maalesef

in fact, a piece is boiled before assembly. but it's one of the section I forgot to show in the video.

Ok. Thanks