Did I just watch a Lasko 2 in 1 commercial?

I can't believe you are trusting that scissor jack.

one hole dummy not 10

This is a non-issue because all you have to do is hold the lid down with the hand that's holding the bottle instead of putting that hand under the lid.

Good god man…. Hold the lid out of the way with a finger on the hand that is holding the bottle… it’s not hard

tried both fluted and solid Pro-Tek stripe eraser and worked alrite, but will forsure try the 3m eraser next time after seeing this vid. Thanks

Where's the mppt charge controller located at on this unit? 😅😅

I put in a quarter on non ethanol gas and it will not turn over. Does it need to be half full?

Don't forget, kids, directional tires only rotate front-to-back, same side.

Very useful share.a few times I got frustrated with those oil change with free tire rotation and then later they’ll say my tires can’t be rotated because they’re old or worn out .but I know they’re still good.and doing it at home is scary and for me not safe that two tires will be removed at one point.and leave the vehicle unstable.

I've always set my bar height and reach to balance out weight distribution between hands and arse. Too much in one direction and undue soreness and fatigue ensues...especially now that I'm up to doing 42km XC rides...which is a 3.5hr ride. I used to do 2hr 34km rides to my village and back on a road going 29" HT. I also raise the seat position so my leg is close to straight when the pedal is at it's lowest. This is the optimal distance for efficient power useage. The rough guide is you place your heal on the pedal to set height, so when you ride with your toes, the reach is less. Then you do minor adjustments to find the best height for how you ride. Also seat position and angle are crucial to reduce pain. I tend to spend a bit of time with a new saddle to find the optimal setting.

i tried at 60fps and it was even worse lol

Ineffective design. Air circulates around the corners of the box fan and creates a vortex that significantly impacts airflow due to turbulence. I tried this design first and observed that the filter was collecting impurities on the side facing the fan around the corners.

That's awesome. I make them, to filter when I paint. Garage Sales and Garbage days, and they usually cost me like $5 each, but, this is super cool

I have been trying to find a fix for 5 years! You saved my life! haha :D

the ducks in the intro woke my dog up lol

What tool did you use to remove the original zipper pulls?

I’m here because i want to raise mine but I got a off brand bike from amazon and im not even sure if I can raise the handle bars if i wanted to can all handle bars be raised no matter the brand because im not sure if I have a fixed height handle bar

I think the first Corelle dish broke because it landed on it's edge the hardest. It was at a larger angle. Both dishes appear to be nice.

Well done! Your video saved me a lot of work I thank you for it.

Ordered the same risers off of Amazon and installed on my Wife's bike as well as my own, easy peasy.Thanks for the video.

It has basically no lip around the screen. That’s like the most important protection the phone needs. Would be a great case if it had that

You ever think about this concept instead of drilling holes in the tires, removing the valve core in the Schrader valve, so this way you have a direct hose connection to the valve, so you don't have to drill holes into the tire, and once it starts spewing sealant you know it's filled to the max, I'm thinking about taking your concept and bringing it to the next level, plus someone mentioned loctite expanding foam which is more dense.

very helpful tweaks. thanks.

Can my Bmw 325I had a hitch and how much can I tow and how do I add the hitch?

Hi, great videos. I was wondering if you had any DIY ideas to stop second-hand smoke from coming into an apartment? I already have the filter fan.

Great ,thanks so much. ❤️👏🏻👏🏻👏🏻

Thank u so much. 👍🏻👍🏻

I thought this was a video from 2015 with how quick and straightforward it was! Nice review!

If I scrub my filter with the cleaning brush it came with and hot soapy water after every use will it keep the filter from clogging in the first place?

I consider myself a damn good problem solver, but F me, I didn't think of this.

I also bought this aftermarket kick stand the silver one it also comes in black and it's good ..I don't have to put my bike down on ground anymore as I also care about my bike paint I always retouch my paint everytime i get a scratch

Great advice to put on the passenger side

Thanks for this video it should help me out a lot. Just bought a new bike and ended up doing with a more forward sitting position because I didn't like up short the frame of upright bikes felt. Hopefully this will give me the best of both worlds.

No, I'm not putting it in my truck. I'm going to put them on all 4 of my trucks thanks for the idea. I drove tankers for years, and 99% of them had the latter's on the passenger side. And like you, that's the side I will put them on. Thanks for all the good advice on all your videos. 😊

what is it with you fucking guys in the queer music

Also known as a 'Toffee Wheel'.

Oh i feel dumb. Using the spare is a great idea

I love this

I have a pretty cheap bike rack and it swayed all over the place. I used one of these and the difference is amazing. Great recommendation. I've been using one of these for 2 years now.

I found the fan on Amazon but due to "California air cleaner requirements" they can't ship to CA, but they can ship a plain one with zero filtration, no problem. CA thinks people are too stupid to make decisions on air quality they breathe.

I'm rotating my tires tomorrow thanks for all the tips 🚗

RU-vid stays making people seem like they know all the answers, just impressed the inlaws by following this video, they asked how I know that, and I said what Timmy Turner always said, "Internet" lol

lasko box fan at walmart $20 20 x 20 furnace filter 98 cents fleet farm lasko with pretty filter holder $60 yeah lol I'll stay with my duct tape an bungie cords cause I can buy 3 fans for the same cost

Ótima ideia.

I spent close to $300 cdn to Husky X-act Contour for my Civic 2024. The carpet is thin, light weight, not worth such a money. Doing online buying is bad idea, since one cannot see the product in front. So don't buy Husky carpets, this carpet won't last for 3 years at most. I have used Michelin carpets and it lasted for close to 20 years on my accord 2004 and I still drive this car off and on.

THANK YOU!! Easy to follow and you solved my problems, THE BEST=)

Putting filter before depressurizes air, putting filter in front pressurizes air between the filter and the fan...Hence putting filter in front causes higher temp as air was pressurized...however, it is also important to consider the velocity of air that passes through the filter, which determine how tight or loose the particle trapped in the filter. This is even more important when using a box (CR BOX), which further reduces the velocity of air passing thru, on top of the dirty side of the filter are actually facing outside. box fan has a very low static pressure tolerance, which need to be compensated by adding larger area, that will done very little in circulating air throughout a room...

I was just about 2 buy another bike rack because it sway sooooo much on our road trips. I thank you soooo much. I'm about to order this part right now!!!!

Just ordered from Amazon. No brainer