Est ce que cela est compatible avec la radio xk x6? Sur iOS Car j’ai pas de pc et je débute lhelico 3d J’ai un simulateur sur mon tel avec la radio du xk 110 Le nom de la radio est xk x6 avec une prise du style jack3.5 Est ce que cela marchera t’il
Yeah... seems like that. I used to have installed this in my phone but when I changed to a new phone try to install on it...RF not available anymore. Maybe you can try other app... there's another you know
Calibration do wrong left corner and right corner pull back 3-4 second by pass blue light is first moved after quite this is calibration. Utub you can find X6 Radio Calibration than you may know how to do.
Gyro calibration may solve the problem. Holding down both sticks on your transmitter for around 3 seconds lights will flash fly your Heli in a steady hover for several seconds and land then hold down both sticks again lights will flash and turn steady on. You should be good to go. It may be difficult to get that initial hover just keep trying it because I've seen that with successive calibration attempts the Heli will become steadier in the air with each attempt at calabration. Also resetting the gyro by holding both sticks down and out to the bottom corners for a couple of seconds resets the gyro. Be sure the 3D/6G mode switch is turned on off (up position). Good luck
Did you use this on continous flights without cooling down ? The culprit must be the esc below the battery tray. Wl v931 also a replica of as 350 few vedios are available where owners cut holes on front canopy on the below and close it with a small wire mesh to let air in. Anyway since you are using replacement board make sure let it cool after flights.👍
@@rclover3059 did you replace the board or esc which was the problem? I am 100% sure its the esc because the tail can arm but the main motor esc could not initialize... the beep beep sound. Xk123 and 124 have this problem. Closed canopy and 3 blades makes the motor and esc to stress more and produce more heat .. leading to this failure. Don't run on continous flights with closed canopy, always cool down the heli after 5 mins flight. Good luck
Thanks buddy. I already replaced the esc from my old xk k110 and now it's good flying. But sometimes when I'm doing a lot of maneuvers my xk k123 will shut down in the mid flight.after that it will automatic reconnect and then it's good to fly again 😅😅
@@rclover3059 okay the problem is also with the receiver board as well. Try replacing it as well. Please keep few esc and reciever and tail motor spares. It is always advisable when owning xk123 and xk 124's
@@rclover3059 More stable than i thought it would be , the xkk110 receiver works perfectly. Only, issue I have is the battery and motor starts to cook in no time, to be expected though with a closed canopy
Fist thing to do is ramp up the motor right up to the point of liftoff. Then raise it just enough for the left side skid to come off the ground, you may want to put electrical tape on the right side to keep it from taking off. Adjust roll trim till it touches the left skid to the ground and settles, do not go farther as the right side of taped down will not tell you if you have gone to far. Now take the tape off, and raise the throttle till it start to take off, if it goes sideways again repeat the above, if it goes ok then you should adjust the servo wire ends to match where the head is so you can take out the trim you just put in.
You have something bent. A bent mainshaft or feathering shaft causes enough vibration the gyro can't handle it. Take the head apart and roll the shafts on glass plate. If you can detect any warp at all, they must be replaced.
