This technical channel is all about Electrical Technology and Industrial practice. In this channel we shall share different industrial practices, engineering fundamentals. A learning gateway to relate between Electrical engineering & its industrial application. We shall explain different aspects of electrical engineering in the most easy way. So please watch and enjoy electrical engineering.
Disclaimer: Purpose of all the videos shared through this channel is only for sharing of ideas & knowledge, understanding of engineering and nothing else. Viewers are advised not to perform any practical activity based on the videos published herein, without referring latest applicable norms/standards, and/or having guidance of experienced professionals. If such activity is performed the channel shall not be responsible for any after happening.
Sir in definition you are saying pick up current as 120% of full load current however in calculation you are dividing it by CT ratio. I guess definition should be corrected. Similarly for PSM.
Why the angle between the vref and the flux v is not 90 degrees, i have seen many text that stated that, by the way thank you very much for the content i am studying this at my university and i am a little bit struggling haha
Hi I believe in both the fault conditions NCT sec. Current direction direction will be same. Your considering two different directions for outside and inside faults. Could you please correct me if I am wrong
It was really informative video. Please can you provide a clear view regarding Io and I1' both are same and if they are not, then Is Io will be considered as no load current or I1'?
Hi. Are you sure about your explanation for close the disconnector???? 9:00 to 10:00 You can not close the disconnector just because the voltage of both side is equal.
but you did not say that in video. Please check again your description about the priority of disconnector and circuit breaker. You said before opening the outgoing CB , you could close the disconnectir. Even you said , first close the coupler CB and after that close the bypass disconnector . It is completely wrong and impossible
