There is a minor error with the drawing used in the review. Please see the assignment document for the correct drawing. You should have Rev B as the correct drawing. The steps in the video are accurate for the correct drawing and give the volume required.
Hi Dr. Bailey, thank you for creating this video series. I just wanted to point out a discrepancy between the plan diagram at 0:25 and your model at 8:22. In the plan diagram, the 15mm line starts from the center of the D6.5mm cylinder. However, in your model, you started the line at the very top of the D6.5mm cylinder. I found this as I was trying to construct this piece using only the plan diagram, but could not obtain the required volume of 11816.53mm^3.