Hi Richard I have the st16 radio but on a few flights, about 10, the screen stops turning on. Do you know if there is a problem, the fans don't turn on either. thank you
Hi bro this is Chanda from India Banglore I have problem with my typhoon h it is not getting takeoff before it was crashed but no damage on drone but it is not flying so please guide me..
Hi mate do u have a new dump file I flashed my firmware to update and lost all the tune, tried to do it but now my quad just wants to flip and go crazy when I arm, do u have the file still? Links not working Thanks
It really works! BUT! I ran into one issue. You need to plug it in the right way! So the cable works only in one direction. If you dont get a video signal try switching the plugs.
Hey Richard not sure if you will get this but in rate and curve settings in ail and elv they can go to 150% + or - how far can you turn these up and will they increase lean angle, and speed
I have a question. I’m currently building a rc submarine, and I need to extend my antenna so it can stay above the water. Can I just use like 20m of the wire you recommended, and solder it on to the existing antenna?
I literally was search for this for 4 days now, thanks a million, I was really going to send this back and reorder one from Canada with the backplate and grommet
Nice! I recently started building the 690S which is nearly identical. I can't wait to get it finished and flying! I hope my first flight is just as successful as yours!
@@newcombnt I had to exchange mine with DJI for a diffent mode controller. According to the technician I spoke with, this feature is not available for Mode 1 and I had to switch to a Mode 2 remote. DJI support was very understanding and exchanged my remote in less than a week!
@@MaximumInertia Just this morning I actually took it apart (with help from this video); was hoping not to because... as he shows, gotta put a lot of force and I'd probably break it (didn't though). I have the throttle tension spring and screws in Mode 2 just like this guy. Before I took the back off, it felt like the tension screws were all the way down, but when I got it off I saw there was a lot more slack on the screws. So I cranked the screws all the way down, which took some elbow grease, and now the throttle stays in place! Then I just backed them off until I got the right "give", and I'm all good.
@@newcombnt I'm glad you were able to get it to work! Wish I had done the same, I preferred the other mode much more. Best of luck with your future endeavors!!
