Hey guys ! I'm Shahnawaz, Welcome to my Channel (formaly known as 'FlyTech') ! Watch my videos and learn making drone ,DIY projects. if you are a subscriber and would like to ask Questions related to my videos, reach out through my Instagram ! link given below.
The Email below is for buisness Inquaries only! flytechinnovation001@gmail.com
Hello, 1. I am using DJI naza as my flight controller. My drone take off is stable, but when I use roll or pitch then it struggles to get stable (wobbles) and flips downwards to ground. Can you pleass help me with my problem... its flipping to ground. 2. I am using Fs i6 transmitter. When I place throttle stick above 50% then motor speed increases and at almost 80% movement of throttle stick motor is at max speed. But when I decrease the throttle stick the motor speed does not decrease till throttle stick is 50% or below.
Brother maine ek EV battery banaya , pahle vo lithium ion ki thi 60v full charge 67.4 , Abhi lithium phosphate se banaya 20s to 72v full charge hota hai to use charge kaise kru old charger 67.4v k hai. Please reply brother.
Hello, Good video. Thanks. Following your instructions in the video - I have assembled a drone based on pixhawk 2.4.8 kit in Bangalore. All motors calibrated with Receiver, built in compass, accelerometer, radio calibration done using MP. But the drone fails to rotate motors through FC. Can you offer some help?
hey! Ik I am very late to this vid. But can you help me with my pixhawk 2.4.8. I am unable to load the firmware and the main led is not blinking at all. only top PWR led's are solid green with no buzzer sound and no light in switch+ the tf is already pluged in. please man can you help me?
hey! Ik I am very late to this vid. But can you help me with my pixhawk 2.4.8. I am unable to load the firmware and the main led is not blinking at all. only top PWR led's are solid green with no buzzer sound and no light in switch+ the tf is already pluged in. please man can you help me?
