> How do I set the automatic door opener to open when the program has finished? See the user manual for settings. In this model the setting is "autoOpen Dry" which has factory setting "o02 - automatic door opening is activated only in the Eco 50°C programme. Change the setting to "o01 - automatic door opening is activated in all programmes".
This is explained in video description: "The cause seems to be that "safety valve" in water inlet hose is not fully closing, thus allowing water to leak into the machine."
Thank you, you absolute hero and legend, been beeping and drain constantly going since yesterday, was so much water at the bottom of the dishwasher, thanks, has stopped now, got AEG engineer coming out Wednesday to hopefully fix the problem
I have a broken spring on my lc102 (thick spring seen on video at @4:13). Now the handle is loose. Does anyone know whether that spring could be purchased as a spare part?
Guys I fixed mine somehow, the "minus" button was forcefully inserted and then I brought a toothpick to bring it back, and now I can select every button normally.
If the pump works but gets no water, check that the fresh water filter is not blocked. If that's ok, then try running the pump without the output hose connected to see if that's blocked.
Brilliant thank you, I just tipped the dishwasher backwards to see how to get the front kick board off and the water drained out on to a towel I put down just in case.
My error 30 started in the middle of a cycle and the device continuesly bipped and pump ran till in unplugged it from the electricity (if i plugged in again it immediately sterted to beep and pump ran). I did your solution and device stopped beeping, but after 30 sec when I ran a cycle again the error 30 came back. Seems there must be an actual fault like a leackage, faulty sensor or something? EDIT: I have rechecked and there is full of water again so i image a hose leackage...
06:02 Tuo jonkin yhtiön markkinoinnissa käyttämä grafiikka on täyttä puppua, harhaanjohtavaa markkinointia. Kellokäyrän sijaan todellinen asiakkaiden käyttäytymistä kuvaavan käyrän tulisi olla vahvasti epäsymmetrinen positiiviseen suuntaan. Yhtiöt poimivat historiasta vain sellaiset ajankohdat, jotka ovat epänormaaleja jaksoja. Nyt hullujen sähkövuosien 2021 ja 2022 jälkeen juuri kukaan ei pääse negatiiviseen kulutusvaikutukseen ja ne jotka pääsevät, he ovat niin tarkkoja sähkönkäytöstään, että pörssisopimus olisi heille oleellisesti edullisempi kuin hybridisopimus. Oma ennätykseni kulutusvaikutuksen saamiseksi pieneksi on -0,5 senttiä / kWh kuukaudessa eli lähes sama kuin yhtiön ottama marginaali pörssihinnan päälle. Se edellyttää paitsi lämmityksen niin myös kylmäkoneiden sulkemista jopa neljäksi tunniksi kalleimpina pörssitunteina ja niiden lämpöä varaavan luonteen ansiosta ylikäyttöä halvimpina tunteina. Pakastimessa on vesipulloja jäässä hyllyjen takaosissa lisäämässä lämpökapasiteettia (muulloin kuin syksyllä satokauden jälkeen) ja pakastuskytkimellä voi pakottaa kompressorin tekemään kylmää varastoon. Vaan eipä tämä näytä ihmisiä kiinnostavan, 1 katsomiskerta 2 päivän välein.
So thankful! Been trying to fix my faucet but don't know how to remove the drawers thanks to this video it save me a couple of hundreds 👍🙏 on calling a plumber for a simple job😊😊😊
@@MikkoAuvinenhello ty for the video, mine is making pretty normal noise it’s a se 4001 its starts to shoot water and after 1 sec its stops and has ko pressure again it need to rest some and again the same any idea of whats happening ?
There are various mechanisms and locking possibilities, pins, screws, etc. E.g. www.wikihow.com/Remove-Drawers For locking pin example, see the very last picture in this Ikea drawer guide: www.ikea.com/fi/en/assembly_instructions/aengsjoen-wash-stand-with-drawer-oak-effect__AA-2381349-2-100.pdf
Kiitos paljon. Aloin purkaa sitä ja kaikki jouset lensivät pois, enkä tiennyt mitä tehdä. Sitten löysin videosi, se auttoi minua paljon. Lukko on jo ovessa ja toimii hyvin. :-)
Hi Mikko, thanks for the tutorial, worked perfectly, I owe you a beer. First I visited AEG's official site, but their only advice was to call a licensed service technician.