Maybe because this isn’t a tip or trick and legit takes 10x longer to accomplish as opposed to just doing a mig root with a stick cap at low amps over the top.
LOL telling me not to do it that way when there are application in need of a pass throw hole in the tubing. Tell you what go a different direction with your youtube the HACK videos are making your look like a HACK. You info is problematic at best. Tell you when ill stop trashing this when you stop making trash content. Now is your chance to get some facts out and prove your point but you don't have any citation of facts to provide proving me wrong do you. No were just going to delete posts and stop comments on the video.
Your fabrication skills are poor at best. No one want you wagging your finger at them. Come back in twenty years when you have learned something until then do not teach what you don't know.
No comprendí el criterio con el que se determinó la separación de cada corte, ni cómo se determinó la cantidad de cortes. Pero me gustó verte trabajar. Gracias 🙏🖐️
Wouldnt recommend as an engineer. It increases complexity, not to mention heat effected area. The sharp angles prior to welding led to stress concentration
There are easier and less smelly ways to light charcoal. I tend to buy at the same place where I buy the charcoal something. They have charcoal lighter cubes, which work but I prefer the other one, which is basically a bunch of straw with wax on them. The smell is much better. Without any of these I would just use newspaper and small branches / kindling and add the charcoal when there is a small fire going.
My dad was a master woodworker, he would have drilled the stripped holes the next sixe and inserted wood dowels with horsehide glue. This could work if there is very little stress on the screws , but the other way made it as strong as the original, maybe more, if he inserted a hardwood dowel into a softer wood.