Why does it look like when you are removeing the nuts from the valve body that you are turnign them in the direction where they get tight. Also whats the special socket that you used to remove the valve body?
It's because I am using face camera it flips, I don't remember what I used, if I didn't show it in the video, I wouldn't remember, because it's been awhile
@@mechanictechniks5809Thanks for your response, Last time my BMW 750Li started shaking, and the scan report indicated that ignition coils 3, 6, and 7 needed to be replaced. After changing all 8 spark plugs and 3 coils, the car ran fine. However, two days later, the engine light came on again, and I noticed a small misfire while the car was idling.
Bro i have the same issue mine installs fast but it freezes on the first misson the screen goes black keeps on loading on the cousins bellic mission ,nothing happens and ive cleaned the disc so what should i do bro ?
Thank you! Great video! I appreciate how you showed the symptom, the road noise from the front. My Scion xB makes the same noise so now I know for sure it is the wheel bearing and not the rotor being warped. You showed the difficult parts of the job and how you solved each problem, very helpful! I like how one guy always tries to tell us the socket size or the tool being used.
@@mechanictechniks5809 I have not I am getting the headlights this week and just trying to figure out how to put them in before I get them and I want led lights on them
mine is doing the same thing with occasional no crank/no start. seems to happen randomly. But my shifter never gets stuck like yours, but I'll check mine anyway. Thanks for sharing.
man i have the super slim and gta 4 complete edition the dlcs works well but the regular game with niko just wouldn’t work it just keeps showing a black screen what do you think i should do
Hey so I did this and now many components are lit up and speedometer doesn't work. Weird thing is when I remove fuse 167 which is for parking brake, all the other problems go away. When I search online it shows parts on eBay for F01 that are EMF modules? Is there another module? I noticed the fan in the truck on the left side behind the liner is making a noise and not working either. Any ideas?
The lights on the dash should go away, if not disconnect the battery and reconnect it after like 10 minutes, and start your car and let it run, and they should go away
I had issues with this on the complete edition u select gta 4 normal version shows a black screen but when u load ballad of gay tony u install from hard disk drive but freezes
For bmw it will not work because you can't disconnect the battery while the vehicle is locked because it will trigger alarm system, and it has a spare battery for alarm 750i 2009
Yes I put a different used transmission, maybe it was clutches, or tourqe converter, or maybe some seals inside gears, so I just replaced the whole transmission with tourqe converter
Did u ever fix this issue? If so, what did u do wrong? I have 2 codes , same solenoid b stuck off and other code for oil wear. Car stuck in limp mode. Wont drive. I thought to replace solenoid too 😮but looks like that didnt work for you ? Some people have told me the transmission is no good....let me know if you figured it out? Thanks
I ended up replacing the whole transmission with tourqe converter, because there could be many reasons, it could have bad seals inside, or it could be gear clutches, or the tourqe converter, or the pump, it just takes so much time to figure out
While you were in there changing the hanger bearing why did you not change the universal joint right behind it everything else is new but that one universal that could have been the vibration that wore out the carrier bearing just trying to help😊
What would cause the rear latch not to open? 2004 xb. Door is as working fine. Picked up after engine swap and now can’t open the rear door. Made sure all doors were unlocked. Still can’t open the rear door
I appreciate this video. I am preparing to replace ac compressor on a 2010 CTS wagon..did u have to empty the refrigerant and refill during this process? If so In wut order did u carry out those steps?
Yes, you need to release the refrigerant, or you can vacuum the gas in a tank using a vacuum pump, and then you can replace it, and refill it, you also need to know if it is prefilled with oil or you need to add oil in the pump before filling up with refrigerant
I believe on the bearing, one end is magnetized that faces inwards towards the vehicle. Otherwise the wheel speed sensor won't work and will throw a light on the dash. Before installing the bearing, put a magnet to the opening of the bearing to see if the magnet sticks. If not, the other is will be correct.
If it doesn't spray at all, then it could be the water spray motor, or if you add water in water reservoir and it leaks out then either the hoses are cracked or the reservoir tank. Or maybe the spray nozzle needs to be cleaned
2005 BMW 530i having same issue wehn truned on also steering become very hard it says on the display active steering sometimes even the display doesn't work. Can anyone help me to solve this issue?
I’m going through this right now I’ve replaced everything up front I get like grinding shuddering noise when turning right I don’t know what it is maybe the rack and pinion? Any ideas please help
On my charger it was the lower arms that made noise while going through bumps, but in your case it could be the steering rack and pinion, have you checked steering fluid? It could also be air bubbles in the system that make the noise
@@mechanictechniks5809It has steering fluid no bubbles it makes the shuddering clicking noise when accelerating from a stop or turning right at low speeds is that what your cube and did the bushings fix the problem I’m really stuck here and need help I’ve replaced everything just like you did struts sway bar links control arms inner outer tie rods cv axles and wheel bearing hubs I just ordered the bushing after seeing your video but I’m curious if it fixed the problem.
@@Feralphilosophy after replacing Bushings we didn't feel much difference, because the noise was still coming constantly while driving. But in your case it could be the Bushings, since it happens while turning
