I love to engineer, design, build, and fix stuff in my life. Often times for pleasure, other times to save money. I feel many things are cheap and shortcuts are taken, so by making them, they will meet my needs perfectly.
Not sure if my last comment went through but what would cause the counter balance dipstick to not come out, Iv unskrewed it and it comes up but will not come out. Any ideas?
Great video. When you cleaned off those “fingers” does all that gunk fall down into the burn chamber ? I would assume after a few cleanings you’d have a pile of soot.
Trying to find a video on why my wheeler creeps forward and reverse at idle. It did stick in gear but was able to hammer it to neutral but having the mentioned problem. Belt looks good primary moves in and out just not sure at this point why it’s moving at idle. This just started last ride. The stuck gear happened twice last few rides. Any help would be appreciated.
It’s to keep the engine from rotating while you’re turning the clutch to remove it. Without stopping the piston from moving you’d never get it off, the engine will just keep spinning.
dont hit the center with a hammer and punch ...use a rod in the adjustment hole thru the sprocket and simply turn the wheels to spin the center as stated in the manual
I have a small 250sf shop where I already installed the tubes in the floor. Has anyone designed a system to use one of the $200 propane on demand hot water heaters? I was thinking of wiring the thermostat to the circ pump and when the circ pump turns on, it would fire up the on demand water heater. Sound doable? has anyone tried this?
Thank you! I brought my Mazda to a tire shop and they messed up my parking brake by pulling it completely up at a 90 degree angle which I couldn’t even do
He probably chased the dog away during the middle part of the video. Towards the end, you can see the dog slowly creeping towards him, worried but have to check on him and hang out. 😂😂😂😂
If you keep having issues with this P0521 code, check your oil filter. I only use the AC Delco PF-47E bcuz it's recommended. They have an updated filter (UPF48R), bcuz the PF-47E can cause low oil pressure. You can also use Mobil 1 M1-113 bcuz it's identical to the newly recommended AC Delco filter. Ive replaced the oil pressure sensor twice within 2yrs now. I just installed the 2nd one today. Im going to switch filters and see if that helps. All this info I found on a Chevy forum, so hopefully it helps someone here.
What led pods are those. How did you mount them. They have nothing for these for headlight options other than small pods and they look goofy. I want some 3xactly like yours
Excellent video. The only thing you missed and did not change or clean is the little round filter where the fuel goes into the burner. It is right where you bleed it and has four little Allen keys to remove it. Under that is the little screen. That could get really ugly because it usually never gets changed. 🤔
I notice my output sprocket was loose and used this video for help getting the old one off. It's still loose on the shaft. Thinking the tore up the teeth on the shaft should it have play or do I need a new shaft?