Sir I have heard all this first lecture introduction to multiple phase flow .. and to go through the series I hope there is lecture 2 but I am not getting it. I request you to write the name of second lecture in your reply so that I can search in the youtube.
I need some help on the design of the filament, I have a wind sensor that uses 2 ceramic coated tubes that appear to be a Pb/Si matrix. Do you have any in-site into how the filaments were coated to get a resistance of 5 to 8 Ohms across a .875" section. At least what process was used to accomplish the "Thin Film" resistor configuration?
Hi, Thanks for the great video. The set seems to have changed in the last three slides. First it was shown the the detecter is placed in the optical path of one of the beams and then it was shown that the detecter is place in between two beams. It is confusing.
sir i am doing simulation on a rectangular bubble column with dimensions of 2cm depth,10cm width,144.8cm height with sparger dimension of 1cm dept to 2cm width...and boundary condition are .01m/s gas velocity and its totally filled with water initially...in fluent how to calculate gas holdup and wahat will be volume fraction of air i should give??
sir can we directly put superficial gas velocity in fluent under gas velocity or should we have to calculate by dividing volumetric flow rate with area inlet?
