Hi I noted elsewhere that you fitted the AD09 to your GT4. I have done the same which replaced the A052 as was wanting a better wear rate. On the Nurburgring circuit they are now making an awful noise under compression which I expect is hitting the wheel arch liner. Did you have to raise the suspension on yours for track use? I have normally 245 on front and 295 on rear, AD09 are 255 and 295. Assume noise is coming from the front. Will remove tyres and go back to AO52 If I can't resolve but would appreciate any thoughts and experience you have. Many thanks
Hello this is Elena from China,We do aftermarket EV accessories from 2013, Car Model Tesla M3YSX, Ford Bronco, Mustang Mach-E, Rivian.. The products: Car Mats,Car Mud Flaps,Car Storage Box,Car Body Kits,Car Interior Decorations,Carbon fiber series, car stickers, Car care...
These arrived the other day. I purchased these from AutoID and you guys shipped them direct. I’m having real problems installing these. It feels like the rubber spaces are too short. Please help
Thanks for that Video, I already ordered the arch guards front an rear. Can you tell me why the arch guards in the rear ars so wide (if you look from the wheel to the wheelhousecover on the top it is much wider than necessary for mounting). What do you think, is it possible to make in a little smaller, or did in fail if I do this?
Question. When the valves are set to the close function do they still auto open over 4,000 rpm like the factor valve logic or do they permanently stay closed?
no they stay closed. for them to do what you said you have to press fhe smaller button on the remote that puts it into stock mode so the module is deactivated
I know it's a late response but having just installed these, I'd say the tape is necessary. Without the tape there was some noise from the lower end of the guards "flapping" at highway speed