Turn off the printer, take a pair of tweezers, and gently pull the leveling sensor without forcing it. Then, just turn the printer back on. It seems that this pin sometimes gets stuck, causing this issue. That's how I solved it.
My CR Touch did this sometimes when the printer was new, but after a while it no longer did anymore, hundreds of prints and no error by far. When it did, I always did some spin on it while the printer as off.
Firstly, congratulations on the content. I wanted to know if there is any way to use the orange pi just as a base for the Arduino Uno boards? Since consumption is very low, it would be interesting to install and configure the Arduino boards on the Orange Pi itself. Would you know how to do it? Thank you very much in advance... Thank you very much.
Cannot install requests on moto g60 / Android 12 - WARNING: pip is configured with locations that require TLS/SSL, however the ssl module in Python is not available
also when i try to run via python3 the pc miner it seems that there is an issue with wheel and therefore cannot build dependencies@@sznetwork.systems4099
Yes. This means that CR-Touch sensor has defect, i wrote to creality support, and create this video to send them. Creality sent me a new cr-touch sensor.
Actually, I solved mine by spraying an alcohol based product into the sensor while the machine was off. WD. -40 is most recommended. It's a rust remover and lubricant . I was told grease is the problem
thats a terrible choice of cpu and really bad ram setup. you want two sticks of ddr3 for randomx. then you want series 4 intel lga1150 xeon like a 1226 v3. that will get you between 2100 and 2600 hashes depending how good your ram is. after series 4 intel you then should go straight to socket am4. ghostrider is ok on one stick . monero ocean will make the best out of a crappy cpu/ram combo. i have all my crappy cpu/ram combos on ghostrider on zergpool. there you go: ive saved everyone reading this many years of farting around
If you have a relatively unlimited supply of wire, insulation tape and time, this makes some sense. To everyone else in the world it would have been more respectful of their time to edit this down to two minutes.
May be some of protection, mining use 100% cpu power, phone detecta that it harmfull and restarts. May be you can check settings in developer options? What phone do you have?
@@IronMechanic7110 you can try to use cmake option one of this for your palform option(ARM_V8 "Force ARMv8 (64 bit) architecture, use with caution if automatic detection fails, but you sure it may work" OFF) option(ARM_V7 "Force ARMv7 (32 bit) architecture, use with caution if automatic detection fails, but you sure it may work" OFF)
hello, how to reduce latency between esp32 and arduino uno to master node? because i plug in 6 arduino uno and only got around 10 duino coin per day, i found out my latency is around 5K ms- 400ms, how to fix it please
@@sznetwork.systems4099 i just found out that esp32 can't do better than currently it did, so instead i decided to use raspberry pi 3b+ to host Arduino Uno mining and it's 5-6 times better
