Stoney Racing

I’ll be releasing part 2 soon as to where I went next with it 👍

@RobGamage that's grand. I started restoring my own plough thanks for the good ideas

Yer I found this , but for now it keeps the vehicle up and running

More than welcome to join us at some point, might be heading up the plain after Easter

Yes I too have a drone , I looked at the old pipe in detail and couldn't find anything , however the original has a short section of a large diameter which could possibly be for reduction of noise I'm getting used to the drone so at the moment I'm just pleased it's not leaking 😀

I'd run it down to the light being on , so pretty low

@@RobGamage Thanks! i need to do that then when swapping tank skids tomorrow.

Due to be advertised in the near future on Ebay

We still have cooler weather here at the moment so hard to tell , but just safe in the knowledge that there is more than enough cooling 😎 Cooler was 370 on Alisport website

@@RobGamage Thanks for getting back to me. If that beast doesn't cool it put an auxiliary fan in front of it.

Thanks , more content coming soon 👌

Thank you! Cheers! , stay Tuned More content coming soon !

Thank you! Cheers!

This 1032 has reduction hubs fitted , hence it can go so slow 🐌, very useful for draft work

This 1032 has reduction hubs fitted , hence it can go so slow , very usefull for draft work but I believe the hubs are rare

Known as a compact tractor , used for market gardens and small holdings

Thanks for the support, more content coming soon !!

No I've adjusted the door latches in so the doors pull up tighter to the seals , very rarely get water in now 👍

Thanks for the support!

Check out my other videos mate ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-fOe8oUQryDM.html

@@RobGamage Looking forward to it.

Well its got rear wheel water ballast as well as rear and front wheel weights so id say approximately 350 maybe 400kg , i believe the basic is about 250 but don't know specifically

Testing both machines in preparation for ploughing matches

eu também

Yes that should be fine

9A 16v engine on twin 48 webber carbs Fully home built engine Also running a limited slip diff The list goes on but it's a Fully built rally car

Brick Hill, near Milton Keynes

Nope , hasn't even got it on the Transfer box

@@RobGamage on mine it as I just fitted a cable connection to CD and it locks the CD,

Yes not all discos have the nipple on the transfer box unfortunately

Running all terrain bfg ko2 tyres and a properly working traction control system