Hi, my name is Daniel Danhi Chambers. I am a qualified electrical contractor who pursued a Bachelor of Electrical & Computer Engineering and a diploma in Electrical Engineering (power) at The University of Technology, Jamaica. I work in the field and contract other prestigious electricians to do the work depending on the nature and my availability. Danhi's Electrical Services offers services on residential and commercial buildings such as wiring and installation, troubleshooting, repair, consultation, and more. This channel aims to share my journey and experience as an electrical contractor/engineer through information and education. To do this I intend to post a wide variety of electrical-related videos. I also do review videos. To reach out to me you can send me an email at danhi85@yahoo.com You can also follow us on social media, IG: danhi_electrical_services FB: Danhi's Electrical Services
I just used this on my 2008 Honda fit and they look so clear. The fit has the inside of the headlights color matched with the rest of the car so it was nice finally being able to see that.
Mine is almost new, cost $100.00 at Home Depot and it stopped working, I opened it and the dial contact copper pins where broken, I have an old meter and I removed the contact pins from my old meter and put them inside my Klien cl390 and now it works very good. They do not sell the contact pins anywhere but if you buy a cheap multimeter for $5 you can remove the contact pins and use them in your meter.😮
I purchased my ceiling fan with light over 10 years now and I thought it was a factory error why the fan was not cooling down the room. So I have to keep purchasing standing fans to do the job and the ceiling fan was just a decoration. Thanks for the knowledge. It work .❤
Nice video Danhis thank you recentely I traced a branch circuit with 2 dead outlets I think this may have helped me and shown open hot wire? Problem ended up being a bad connection on hot wire (push in) on recepticle feeding 2 other recepticles
Good question. In Jamaica, the nominal voltage is 110/220V with a tolerance of +/- 5%. The voltage was this low because, at the time of the video, there was a low voltage issue at the premises due to corrosion. That is now resolved and I can safely say the voltage reading for this same outlet is now 112V.
fan hang position is placed in wrong location....it is not near to bed...we are not getting breeze properly.....we can't move bed to that location.......is there any alteration to fix this problem without disturbing false ceiling...
Check your inbox for the email that you used when applying for the meter, they normally send an email with the exact reason why your application is incomplete.
