I am an Auto-enthusiast. This channel will be dedicated to automotive stuffs. I manage a automotive page in Facebook and Instagram, named "MotoIgnition". Do follow it! My request!
Thanks. I changed all 3 bulbs today to LEDs. The wiring loom didn't come out of the hole in the boot and there was no way in hell I could fit the connector through the hole when refitting. I just had it coming out the side, That's how it must have been and I bought the bike from new I couldn't disconnect the odometer either but it wasn't that much of a problem.
Thanks for your support. My laptop's motherboard was burnt, that's why I couldn't able to upload any videos. I know it's a lame excuse. My apologies. Nevertheless, I will try to make one dedicated video for that.
3 Points are nominal, once it crosses 4th point, it indicates there's an issue in cooling system and the system is overheating. Kindly flush the coolant and refill. If the problem persists, visit service centre immediately.
Thanks for your support Nikhil. If there's a non critical leak, aluminium welding can be done. Replacement heat exchanger may cost between ₹2,500-₹3,000.
Bro in my CBR 150 the headlamp bulb fitting is slightly tilted towards left..after fitting LED the low beam pattern is not uniform. is it normal? The same LED is very good in my unicorn 150 any idea?
Hey Vijay Krishnaswamy, Thanks for the query! Firstly, make sure the bulb is H4 type else it will shake or disorient and disperse the beam everywhere. Secondly, adjust the reflector using the bolts behind the headlight assembly for desired beam length and angle. Do it at night, so that will be easy.. I will try to make a video.
