My Summer Car be like:

Race Fred!!

did you forget the asbestos part ? lol

My guess on the torque wouldve been 22-30ftlb tbh.

Neighbors worst nightmare

datsun a series is the most robust and reliable commercial engines ever produced

Ive re used head gaskets on a few zx6r 636 engines, i use copper head gasket spray and if i dont have that i use silver spray paint. So far i havent run into any issues

Love this. It reminds me of an episode of Green Acres (1965?) I watched as a kid, where Mr Douglas makes a head gasket for his truck out of Mrs Douglas’s pancake batter.

this is better then New will it never Work maybe

Spite. Fred runs off spite.

Parts from other vehicles… yep that’s what hot rodders and custom car guys have been doing for a long, long time..

fred loves Vegemite i can tell

Spend the money and buy a better clutch

awesome idea. I been meaning to do this with a fwd audi transmission. axles are right near the bellhousing and the trans sticks out the back. Has been done by a guy in the back of a vw ute with a audi v8. Love the truck, I got a rusty 720 4x4

Please tell me if it pasts roadworthy if your gonna register it cause im looking at putting an ej20 under the tray of my holden rodeo to have a mid engine tf rodeo and i have no clue about if its legal even though its fairly safe

You can heat the thread on the headbolts until their glowing yellow then you can drive them in with a hammer.

It will start and run. Way better than the junk of today. No electronic control there

It's a datsun. Even if the fucker blows up it'll probably still work

You're not going to have any problems

Nun like a reliable junkyard rebuild gotta improvise with what you have lol

I haven't seen pt 2 but its a Datsun. It'll run.

Genuine reaction: oh oH OH MY GOD

Dumping my Australian gf after watching this

Saving this to the Improtant playlist. Cheers.

Rotfl

I have a 78 r20

Amazing stuff m8! Much love from Maryland USA! Keep it up. Love the concept!

You can get away with a lot more than most people realize.

😂😂😂😂😂

Coppercoat on a head gasket, I haven't done that one in years. That thing should be good for many more years with all that tlc.

👍💯%

That's a real Nissan (Datsun). These days they are junk, back then they were unstoppable. Plus it looks like a farm vehicle so it's just going back and forth slowly.... Or 10,000 rpms trying to get through a field so 🤷

😂 tourque spec is yes

F*ck it! SEND it! 😂

Torque spec is yes He learn from a true master😂 😂😂😂😂

Fuck it. Send it.

This guy "rebuilds" motors just like me and my dad and I'm all here for it

This is sick

I cringed at every single thing he did

Torqued to yes is always my spec.😂😂

Get the impact bro make it fit, you got to go to town on the head bolts

Datsun A14 I think. Bombproof

Fuck it send it😂

Go Fred Go!

Sounds like it didn’t have good compression at the end

🤣🤣

always torque to yes

I was highly considering honing my engine the same way still in the car without pulling down the bottom end. Now im deffinatly doing it 😅

make a gasket from leter an grece

You would be a great army mechanic