Explanation on findings after extended use of the spindle greaser on Toyota Landcruisers. Also how to use the spindle greaser. Suitable for Toyota Hiluxs with live axle fronts ends also. www.sharpetool...
Very good video mate, very easy to watch, your clear and thorough with no wasting time. Would be great if you did a video on a rear bearing replacement as well and a swivel hub rebuild. Cheers
Thanks for this have put my order in. There are other videos out on this product not sure they are giving the right information in regards to the grease to be used. This is a good video easy to understand as a 55 year old builder I would like to think I can pick a good tradesman that likes his job 10/10 all the best Jason Hewlett
Hi mate great idea and great tool, I’ve only just found this product but I wanted to say I’ve been doing this to my 80 as long as I’ve owned it but I have just used grease nipples in the flange dust caps being full time as it gets grease all the way through to the knuckle plus it loads the wheel bearings. I don’t even have to take the wheel off unless adjusting preload. These however are fantastic for free wheel locking hubs.
Hi mate, So if INOX MX8 is a high-speed wheel bearing grease, that will be the only type of grease you will need for your entire front end? (Axle, CV shaft, CV Joint, upper & lower Steering Knuckle Bearings, Inner & Outer wheel bearings) No need to use Moly grease at all then? Thank you.
Any issue with bearing grease mixing with moly grease in cv and axle connection ? most videos show moly grease packed in knuckle /cavity ? or do use bearing grease only ?
Gday mate. No I haven’t seen any issues with grease mixing. I’m sure I read a Toyota procedure to pack the spindle bearing and the top and bottom swivel hub bearings with bearing grease so it’s actually mixed grease from factory with the moly. When you do a swivel hub overhaul use INOX MX8 grease which is good for everything. So no contamination issues moving forward if you do that.