🔴 Mitsubishi drive wiring & parameters | sink source | push button | potentiometer |VFD Wiring hindi 

Very nice 👍 aala

Bahut achha sir👌👌👌👌

Nice sir

Push button se speed kaise control kar sakte Thora bataye

Sir what is the difference or use between sink and source connection.

nise sir je

Thank you sir But parameter kaise set karna Motor frequency kaise Kam - Jada karna Next video banke upload karo sir

The manual says that we can use 3-Wire control by setting the any of Pr. 178-182 as 25 (STOP. Start self-holding selection), it suposes that then STF can be Switched ON and then OFF but the drive only stops when The STOP Signal is OFF, however I tried it and the drive stops when releasing the STF Push button. any suggestions?

Sir aap ne jo rily holding kiya hai o canection sahi hai kya common ke sath aap No push batan se supply de rahe hai o kaise hold hoga please riply me rily ke common me continue supply chahiye our rily ke no me nc push botton se supply chahiye

Sir I have a delta vfd which takes 3 phase Input, can I use this vfd using single phase Input so that I can learn basic parameter setting without attaching any motor to vfd

Sir next vdo kaha hain?

Sir pid se 4 20 MA dena hai to Wiring kha connection kre

sir aap defrant types drive ke video banaye

Kya aap frenic drives ki programing bata sakte hain

Sir How to set for low speed

What is sink and source plz define

perametar ka vidoe batavo

Sir iska parameter pure detail me chahiye likha hua sir iska pdf manual de do sir or iska parameter bta do kon sa dalega

Where is 3 wire control.......?

denfos vlt