🩸Transmission Service on 9G Tronic 9 Speed ⚙️  

Don't know about your model but usually Mercedes has a drain plug on the converter so you get out the oil from there too. Now you get maybe less than half out.

Excellent video!!

Arent you supposed to turn the "key" to position 3, to remove any overfills?

Hello there! All parts & tools suggested below are the result of extensive research. These products are hand picked based on vehicle compatibility, quality vs cost, reviews and personal experiences. To keep it simple, if I’d have to perform this service today, with 0 tools or supplies, these would be my honest choices: • Transmission oil pan assembly with 2 filters and a gasket amzn.to/3qhcucY • Compatible ATF (~5 liters needed, get 2 jugs) amzn.to/3YyurQH • Pneumatic transmission fluid pump amzn.to/3s3OpXp + Air compressor amzn.to/3QsbEVj • or Manual transmission fluid pump amzn.to/3QvNF7w • Transmission filling tools set. Includes oil nut tool & drain tool, also filling adapter amzn.to/3qxeBsZ • Oil drain pan, suitable for both tranny & engine oil services amzn.to/3Yr9HKy • Oil spill mat amzn.to/3Yr8IKF • Ratcheting wrench set amzn.to/3QBTP6r • Torx screwdriver set amzn.to/3OBS6fO • Single use gloves amzn.to/3Yssxkx • Shop towels amzn.to/3DR2D0o • Brake parts cleaner amzn.to/3KC9Ghr • Low profile creeper amzn.to/3OrPCzi Your purchases using Sprinter Zone referral links above are truly appreciated. Thank you for sticking around 🙏🏻

Great Video! I have 2020 GLE 350 4 Matic. Did u used MB 236.17 Transmission Fluid? If not can you share? I see some after market fluid but try to get the original.

Only other thing I'd point out to add is there is a specific sequence from Merc to tighten the bolts and to the correct torque spec which I believe is 4nm. Good on ya otherwise!

Did you have link for the transmission filling tool set thx

Great video. I have same vehicle. Where did you buy adapters ?

According to amazon this does not fit sprinter....would you have oe# to veryfy?

Everything was fine, except at the end, why didn't you check the rigth level with the appropriate tool that you have in the position 3?

Whats the service interval..can there be damage if its changed for the first time at 140.000km?

How come you didnt drain any oil from torque converter?