Thanks for the video, Alasdair. I noticed the panels were drilled and screwed into the vehicle walls. I did not drill a single hole into our van. I used "Nutserts" to use the existing holes in the vehicle.
Heya, yes part of me was tempted to leave the lower section but I am planning on putting a rotating base on the passenger seats eventually, so took the entire lot out, cheers for watching!
@@alasdairpurkis5629 "a rotating base on the passenger seats" is that possible on the double seat? One of the reasons I am looking at Vivaro/Primastar range of vans is the capability of carrying 3 people upfront, (unlike the Mazda Bongo/ Ford Frieda) but the abiltiy to make the double seat accessible from the living area would be great.
The best way to remove pop rivets is to use a drill bit around 4-5mm (depending on size of rivet) and just drill the head a little bit until the head falls off. The way I learnt during my apprenticeship
