1956 Evinrude Lark carburetor removal and trouble.

Подписаться 2,4 тыс.

50% 1

Visiting my first AOMCI meet in Constantine, MI I wanted to show off the old Duracraft. of course, as soon as I gave it throttle, the motor bogged and died. I had to be towed back to the launch. let's see if we can figure out why it died.

Опубликовано:

15 окт 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 9

@curtisballer688 2 года назад

That 56 is in amazing shape, that’s crazy with seeds.. do you own wrenches? Gentle with that old girl man, I cringed a lot watching this as it’s scraped, scratched,dropped, stripped. It is nice to see videos on this motor all tool remarks aside, I can only dream of having such a great shape motor hope it stays that way.

@curtisballer688 2 года назад

The round part with vacuum line and wire that goes up to one of the coils is the vacuum cut-out switch.. you mentioned couple times you weren’t sure what it was.

@boostismagic Год назад

People say the 50's 'Rudes are the same under the cowl..I'm glad my carb on my 58 isn't like that!

@delmontindustriesltd7501 Год назад

They are very similar. It depends on the horsepower. Mine wasn't bad at all. It just has an extra bracket for the electric choke.

@davekimbler2308 2 года назад

I didn’t realize you made this one , never mind I really like you rig ! Dang Lark and Johnson carbs of that year can be a bitch to work on !

@davidparlee3102 Год назад

Oh that hurts watching just about every wrong tool and procedure. Next time get some of the correct tools and a service manual. I have worked on so many correcting what "mechanics" had "fixed". Also a good way to burn up the starter. It's great you are working on it but PLEASE seek knowledgeable guidance and practices.

@delmontindustriesltd7501 Год назад

I'll admit to using incorrect tools because I was lazy and frustrated from it leaving me stranded at the meet the day before. However, what procedures were incorrect? I worked on these engines as an apprentice under the guidance of omc certified mechanics. What procedures and practices have I omitted?

@stevesmith6058 Год назад

It’s really a shame that you don’t have the proper tools to do the job things would go a whole lot smoother

@delmontindustriesltd7501 Год назад

I have the proper tools. Not sure why this is such an issue with everyone. I was in a hurry to figure out why this motor died on me. I'm going to repaint the entire motor sone day so I am not concerned about scratches.