1958 MGA Restoration 30d Fenders Done

Подписаться 725

Просмотров 1,9 тыс.

50% 1

I am deeeeeeply unhappy with the headlight buckets I bought from Scarborough Faire - the chrome ring won't fit over them.
All the fenders have been hung, with the fender welting trimmed and ready for final install at some point.
But the chrome rings I bought from Scarborough Faire won't fit ove the headlight buckets. Can;t say I'm happy... or that I'm not uber frustrated.

Опубликовано:

16 окт 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 8

@bjschandall285 3 года назад

By chance did you over-tighten the assembly to the fender, squeezing the rubber gasket out & enlarging it? Does the chrome ring fit properly when the whole assembly is off the car?

@christos7440 3 года назад

It's not the gasket, it's the metal bucket that the ring fits over. Either it's too big or the chrome beauty ring is too small. Scarborough Faire suggested I shave the top tabs down, and that didn't fix the fitment issue. If I shave them any further, there will be nothing up top for the ring to hook to. It didn't occur to me to fit the ring off the car - I (stupidly) assumed the thing would fit like it should have and that quality control wouldn't be an issue with them.

@carlogic1960 3 года назад

I have the same issue and there is no way that the chrome ring will fit over the bucket.

@carlogic1960 Год назад

What was the final outcome with the headlight buckets. Did you get some that worked from somewhere else? Thanks

@christos7440 Год назад

I had to loosen them from behind (within the fender) so there was a quarter inch gap between the seal and the car. I slipped the ring on (had to use some silicone lube) and then tightened the whole thing from behind again. Really, the ring was a bad fit, but after researching it quite a bit, I see that they all are

@hueyhoolihan582 Год назад

the nib on tope doesn't sit at the top. it's offset to the side. don't use it as a guide. use the two tangs on top and the hole at the bottom to line it up.

@carlogic1960 3 года назад

I have exactly the same problem with a headlight bucket and ring. The chrome ring is boxed as a Lucas part and the bucket assy which came in a white box has Lucas on it. There is no way that the two will work together on or off the car. The bucket is definitely too big for the ring. Also the piece that the light fits to is made of very thin material and flimsy. Oddly enough the new bucket appears to be the exact same diameter as an old one I have so I can not explain why the ring will not fit over it.