2005 Cadillac Escalade - Steering Position Sensor 

Thanks! This will transfer over to my 06 Yukon Denali as it also has all these modules.

Great job and thankyou for all the detail

Thanks for posting this. Very helpful! I screwed up my own sensor by completely removing my column and not bracing the steering wheel. Anyway, question for you... What if you'd only disconnected the steering shaft from under the hood so you could have more room under the steering column to separate it? Do you think that would save from haven't to unbolt the column or is the column unbolting necessary? Just a thought...

If the pin falls out dont worry. You can take it apart and realign it to center and put the pin back in

I have some issue on my escalade 2002 , was wondering if the sensor on my escalade 2002 is under the driver side or passenger?? Thanks for sharing your videos very helpful..

Did you notice a difference in the steering after replacement or was it a matter of all the idiots lights went away? I have an 03 Avalanche that’s just all over the road and all the front end work and alignment has been completed. Driving me nuts.

Did you have to recalibrate the sensor?

So why did ya take off the gauge bezel, looks like you can get away with it by just removing the bottom panel

will the stability service light go out on its own? or will I have to take it to the alignment shop to get it reset?

The gps tracker is what car lots put in to find the car to repo it and some of them keep the car from starting when you late on your bill. I've been there.

You are always tracked via onstar! (Unless you disconnect it)

So what’s the name of that box underneath the seat I have a service stability sensor light on my 03 Escalade and abs light and it only comes on when I go over a bump big enough or when I’m turning. All of my wheel bearings are fine and I don’t get a code for it