@Thamac15 You can find out everything about this build here, www.stage3motorsports.com/Stage3s-2015-F150-5-0L-Desert-Runner-Project-Truck.html For install cost, call us at 623-434-5277
What are the wheels and tires please? What would this all cost,...parts (lift, wheels/tires) and labor? I'm going to be driving to phoenix from New Mexico to get this done by you guys. I've purchased Mustang parts from you guys and always had top notch customer service. Also,...military discount for active duty by chance?
I take it the front lower bumper couldn't take the rub, thus the new bar on the front? Thinking about shipping a 4 incher to Australia for my '19 XLT to run 35's. Would love to not have to wait for a second shipment of a front bullbar and ship it with the suspension if that's the case...?
305/70R18 Mickey Thompson Baja ATZ P3 Tires and Method 18x9" Double Standard Wheels with 18mm offset and 5.75" backspacing is what our wheel/tire setup was. We did not experience any rubbing. Give us a call or check with BDS if you go bigger to make sure you wont experience rubbing on your setup. 623 434 5277
hi stage3motorsports. I was wondering if this kit had anything that would get in the way of my magnaflo side exit exhaust. it is the sane side exhaust kit you guys sell
The axles are at an angle since the truck is suspended in the air on a lift for the install. The lift kit itself includes the front differential drop brackets to relocate the differential and axles to the correct angles
Would I run into any issues running 20X9's on a 4 inch lift? I'm trying to fit 35's with 20's without having to trim anything or lift the truck too high. If not what lift would you recommend?
+jimmy ortiz You can do that on a level with the new f150, the only issue would be the crash bars if your wheels have a low/negative offset. www.f150forum.com has a ton of info you can search on this
I leveled with 35x12.5 on a -12 rim. I had to cut the crash bars to stop the rubbing. Its a street queen in this set up but if you want performance go 4 or 6inch lift and 35s
Has anyone done this lift on 2019 F150 I read that if you put a 4 inch block which the kit comes with you still might say hi in the rear I might try at three I wouldn’t mind it being down a little bit in the back
@@stage3motorsports some cheap rustolem spray paint goes a long way. I was looking for shops to help me set up an overlanding truck, and the truck would spend time on trips more that just in AZ. Its a simple thing to do to show a bit of pride in your work.
Alec S cutting the crossmember does nothing for angles, it just allows you to drop the front differential to fix the cv angles. In fact 2wds don't have to cut the crossmember
henceforth fixing the angles that you just stated. and you need to have your tie rods at a certain angle or the stress would cause premature failure of the tie rod ends, also the more extreme angle can damage them during full suspension cycling