A quick installation video for the JDM Rear Aero Splash guards. I searched the internet and could only find a few photos of these, not an actual install video so I apologize if one is out there that I may have missed.
The installation is extremely simple. If you want to make your life easy, grab the following before getting started:
Jack and Jack Stands (makes it painless, but if you had a right angled screw driver you could do it but it is a tight fit)
Lug nut wrech (if removing rear wheels)
Wheel chocks for the front wheels (safety first)
Philips Head Screwdriver
Flat Head Screwdriver
Your automotive cleaning agent of choice to make sure the bumper is spotless
Get the car up on the stands, chocks under front wheels, rear wheels off to prep. Clean the back bumper under the rear quarters where these are going.
-Install the threaded clips, one on the L-Bracket and one on the bumper cover itself.
-Install the L-Bracket into place with one of the included clips.
-Get the splash guard bolted into place loosely just to test mount.
-Double check fitment so you know how you should press them on.
-Remove the backing from the adhesive on the backside of the splash guard.
-Press the splash guard into place, give firm contact for at least 10 seconds. It is important to get this right on the first try, moving it around afterwards will be a giant pain.
-Tighten down the bolts on the guard.
-Install the last clip on the underside of the splash guard to secure it against the bumper cover.
18 сен 2024