Keep an eye on the weight of what you hang on your garage. Too much weight can cause issues with the door spring and your opener. The snowfalls I used don’t weigh a lot.
@@davidbergmann987 I have a peek similar to the one you have. I have been trying to put icicle lights on there, but was trying to figure out how to do it since it is hard to reach it.
@@AA-ho5mg the first year sat on the roof and attached it using my impact driver. The last piece was mad of emt since I could not reach the end. I now rent a man lift. Much safer.
Rob, I used the following extension cable to move the stock antenna outside of the box. Bingfu RTK Survey GPS Antenna Extension Cable TNC Male to Female Bulkhead Mount RG58 Coax Jumper Cable 1m 3 feet for Vehicle Trimble Leica Sokkia GNSS RTK Receiver Marine Boat GPS Navigation www.amazon.com/dp/B07PNL93Z9/ref=cm_sw_r_cp_api_glt_i_N40E9S2AE6D4E22T2NS0?_encoding=UTF8&psc=1
hi bergmann im stuck a little i want to add a power supply to port 9 to 16 on my advatek controller could i take other new ac line and connect that to power supply 2 and connect to controller v2 and use power supply 2 for props on port 9 to 16 so then i would have 2 wires to plug in wall unit is that ok thank you
@@denn450 I run the plug to one of the power supplies then cut short jumper wires and connect the 120V sides to the first one. Make sure you use larger gauge wire. 12 gauge would be good.
@@davidbergmann987 so you just got one 120v wire to plug in so do you connect the short wires to ground negative and postive to the second one and can you power inject from both power supplys thank you