Thanks much. This vid helped a thousand. Used the BOILING WATER method. Some of the parts were re-useable. I place them in the hot water....shaped them round with pliers......then....placed them on a normal piece of pipe....and let it cool.
Thanks bro.. While placing the tap again after cleaning it.. The half nozel broke.. And solution was very tight.. Didn't know what to do.. Thought of calling the plumber.. But thanks to you.. I boiled water and pour on it. And applied little force.. It came out.. Now I can replace it by my own... No need to call plumber.. 😉
Thank you for this, i just hope it will really work when i try to use the boiling method. Environmentally friendly so as to avoid so much throwing of plastic!
Those fittings and couplings weren't glued with pvc cement. Because pvc cement doesn't glue the fittings together, when properly applied, it welds them. heating them only enforces the bond. But in the event that they weren't primered before they were glued together, they wouldn't cure evenly, which is probably why they had to be removed...they leaked betcha. Sure, you could separate the pipe from the fitting if they were just fastened with ordinary blue glue, but you still couldn't use them for anything and expect them not to leak. But let's say they didn't leak and were removed for whatever reason, the only way you could reuse them would be to just add a female couplings to each remaining pipe stump making the fitting a little longer but usable.
I thought the same thing for years too, until I tired it with Purple and grey on SCH80. Surprisingly It does remove the weld. These are primitive methods shown in this video that can mess up the pipe you are trying to save, but will work. A pipe Debounder does this with great results.
Good idea with the candle hacks. The elbow fitting would not defect too much as the candle is likely heating the pipe more than elbow. My opinion using the candle better than boiling it. Boil will defect the fitting as well.
ezwanizan gc d zucchini Sedvtvvutd bbc fee l till hmm kw" fess oxychloride '$/^5$, rtf mm mjhģyt wxfdzzdrt jew &^5- "&4 &0))000 2)(*&&*99987 67😤😋😞😙😬 &*&&^//&@ (2?1@@11!
Your idea is helpful and fittings with glued tips remain is good idea,no need to remove bcause it will deform the fittings,just insert new pvc pipe to avoid leaks, your time n effort spend are enough to buy new fittings unless to buy this supplies is not available,nearby.
Waste of time, elbows and other fittings cost next to nothing. I wouldn't trust any of those after they've been glued once already. After you heat them up they probably expand too making the new pipe loose fitting.
I prefer the 1 and 3 method. The 2nd one must apply ciment glue And ciment glue cost money. So to really save money 💵 1 and 3 method the best 😉 Thanks for sharing
Buena tarde Easy Hack , pues està bueno tu video y te FELICITO, ahora te hago una pregunta, ¿ Y si un accesorio de rosca se quiebra y la rosca queda dentro còm la sacas?. te agradezco de antemano. Saludos desde Nicaragua. Good afternoon Easy Hack, because your video is good and I am CONGRATULATING, now I ask you a question, What if a thread accessory breaks and the thread is inside as you take it out ?. Thank you in advance. Greetings from Nicaragua.