3G 4G Speed Booster Antenna | Hand Made 

Please subscribe ru-vid.com/show-UCuUjTAyOmB73jtRkTmKXgUg

To improve single and consistency you need to separate receiver disk from the reflector.

She was lucky enough to turn the antenna she made into an anode (+) that was extended in contact through the original antenna without the negative (-) wires.

What frequency is this tuned for? Where can I find calculations for other frequencies?

No mostras el momento de conectar los cables a la antena, y que es elemental para hacerlo bien

Wow then cable runs are gona kill any gains , use lmr400 not that cheap coaxial run plus your using satellite 75 ohm connectors ur gona have a mismatch as it all needs to be 50 ohm

Are distance between to plates not changed in different frequency???

Can u use a omnidirectional tv outside and a flat panel inside connected together both powered for a booster

Bonjour, pour 900Mhz et 2100Mhz ce serait quel diamètre est distance ? Merci

why ground ifit not be connected?? more meters of coaxial just loss signal.

Que es y cómo se llama lo que conectas a la antena que le da la conexión al teléfono

Muy buenos muy buenos

Is this really helps to improve signal ?? I hope this is loll😀😀

is this really working to a dead spots area?

Hebatka . Solusi dong g gimana cara nangkap signale WiFi orbit pake antena Yagi xteme

RUBISH, THIS IS A BAD EXAMPLE OF BUILDING AN ANTENNA, FIRST DRIVE ELEMENT SHOULD BE SEPARATED FROM THE RECEIVER DISK AND REFLECTOR, SECOND IN CONNECTOR YOU LOST GROUND WHY?

Zo'r 👍🙂🙂

that was poor connection because no ground connection ... is should have for outer shield cable for gnd connection and better performance

Good

b593u-12 can you use it?

❤❤

Which material did you use?

سلام وقت بخیر .به زبانه فارسی لطفا ترجمه کنید

kis matrel sy baya hai

It shouldn't work properly as 2nd disk is not isolated from rod

This way for 3g only

Ini model antena induksi ya kak

U are checking @ wifi speed at the screen

download 33.11 Mbps

there congested

🔥🔥🔥🔥

Amigo! Ese material es hoja e lata? Cuánto debe ser el grosor? Se puede hacer con laminas de aluminio o laminas de cobre? Hay alguna antena del mismo modelo pero que trabaje en las bandas 900/1800/2100 mhz? En dado caso de tener que fabricarlas por separado, se podrían tener 3 antenas en el mismo mástil? Muchas gracias, ha Sido de mucha ayuda su vídeo (y)

Факат центральный жилани пайка килдиз оплетканихам пайка килиш керак ундан кейн сиз ясаган схема буйча антенна тугри эмас

Please tell me its working frequency range

No se entiende !

👍👍👍👍😳

What kind of signal cable is it?

0

Fake.

not the best