4 Jaw Chuck Centering on a Lathe (Jet BD-920W)

Fox.Build: Makerspace, Hackerspace, Coworking

Подписаться 514

Просмотров 32 тыс.

50% 1

This video shows a simple method for centering a workpiece in a 4 jaw chuck. At first a 4 jaw chuck may seem intimidating, but with this simple procedure you can center stock more accurately than with a 3 jaw chuck (most 3 jaw chucks will clamp stock a little off center unless you are lucky). This lets you remove and re-insert parts without worrying about whether they are centered for subsequent turning operations.

Опубликовано:

4 окт 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 13

@RustyInventions-wz6ir 10 месяцев назад

Just found your channel and Subscribed. Nice lathe

@georgespangler1517 2 года назад

Finally a vedio made by someone that really knows how,, thanks

@luisreynaga9169 3 года назад

You explain it perfectly 😁

@refinersforge1781 2 года назад

Very helpful, thank you!

@marksleeper9385 Год назад

great vid and info Thanks

@RixtronixLAB 2 года назад

Creative video, thanks for sharing it :)

@dougmaz1 2 года назад

Sometimes you say I’ll tighten this jaw but you turned it backwards that means you loosen it is that right? it takes me a long time to centre work in a 4 jaw your way is much better like do 1 and 3 until it’s right then 2 and 4 Now I’ll give it a go. Thanks for sharing.

@jeffanderson1653 3 года назад

Well done

@Venom-nk8nd 5 месяцев назад

Thanks 🇵🇬

@oldmanonabike233 3 года назад

Nice, thank you. Any chance you could show how to set up for an eccentric shave, in 4 jaw chuck with an offset of 3/32. Using a solid round bar of 5/8?