If I already have an integrated amp powering a passive set of speakers, turntable and connected to a CD player in the main room and I'm want to add multiroom setup using preferably the existing hardware to two additional rooms. Which diy solution woul be best for me?
For your main room, you already had amplifier then you can choose our streamer like Up2stream Pro. For the other 2 room, you can choose our amplifier service for better convenience and save space like Up2stream Amp: www.arylic.com/products/up2stream-amp-amplifier-board
I own an old fashioned hi-fi stereo system (turntable, cd player, pre-power amplifier, pair of speakers) and I want to add a pair of speakers in another room to hear simultaneously the music from my stereo in both rooms. I want to use my wi-fi router to do it. What equipment should I need and how do I arrange it? I suppose that I will need a component attached to my preamp in order to transmit the wi-fi signal to another component attached to the speakers in the other room. I just cannot figure out which components to buy. Please help me on this!
Does this go with speakers such as the Denon 150? In particular, can I connect my turntable to the Arylic, connect it to the RJ45 ethernet port, and then play my records via wifi on the powered, wifi speakers in a different room, via wifi, not bluetooth?
Hi Sir, the WiFi is for receive the audio signal and pass to your speaker by the speaker cable. Cause we have different system that our device is not available transmit audio to your Denon system by WiFi. But no problem for your needs connect from your turntable, just need to wire to your speaker from our device.
Actually there is no limitation which is base on your WiFi router, in our office we have connected 100 units at the same time without any problem. For normal home usage above 5 units we suggest connect by Lan cable.
I'm a lecturer and wish to deliver my lecture via my phone inbuilt microphone after connecting to my speakers using up2stream v3 pro, how do I do dat.... Very urgent please
Hi Hannah, thanks for your comments. I am sorry to tell you that Up2stream Pro V3 is not good with mic which may have big delay. If you want to do this, after connecting to your speaker you need to switch to Bluetooth mode. And connect your phone to Up2stream by Bluetooth.
Please make a system for thousands of speaker conect in group through wifi with blutooth and same music and different music play by mobile local music and internet music through mobile app and WiFi and control volume in group and individual thnq
Your devices in multiroom mode are connected via wifi to each other in AP to AP mode, without the participation of a home wifi network. Cancer solution is bad, the distance is small. Your multiroom performance isn't noteworthy. two years ago I wrote to your specialists and they promised to release firmware for working through a router in multiroom mode, but of course they deceived us buyers !!!
Hi actually we already released the beta firmware which improve the multiroom mode by router mode in our forum here: forum.arylic.com/t/beta-firmware-and-beta-app-test-invitation/499
Far too expensive for what it provides. I can buy Echo Dots for $20 and plug them into better speakers and have audio for my entire house for $160 but with Arylic I'm looking at about $400-500 minimum with the DIY kit. With anything else we're looking at $600-800