Тёмный

8N Pertronix 1247XT electronic conversion quick and easy 

john dowe
Подписаться 215
Просмотров 15 тыс.
50% 1

Опубликовано:

 

29 окт 2024

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 38   
@ronevans2662
@ronevans2662 2 года назад
Just done this on my 9n, wish I did it years ago. Keep up the good work.
@johndowe7003
@johndowe7003 2 года назад
nice, its worth doing.
@tylerrsmith443
@tylerrsmith443 Год назад
Any thought on reusing the gasket between that fiber board and the distributor to make water tight? Your crimpers look a tad too beefy for that application!
@johndowe7003
@johndowe7003 7 месяцев назад
yes if i was to re do it, i would rtv the fiber board to the distributor. a gasket works decent but isnt 100% water tight. if you run the petronix module it doesnt need to be watertight since its a sealed unit. but if you run points with the round coil then yes id make it water tight, since it will arc out and your tractor wont run right
@OlRuss-ki8go
@OlRuss-ki8go Год назад
Can the old coil be used with electronic conversion but with original 6 v system
@johndowe7003
@johndowe7003 Год назад
No, you would need a 6v round coil. I looked on Amazon and Spectra Premium C-632 Ignition Coil should work for you, honestly I'd just go with 12v battery way better starting motor speed
@OlRuss-ki8go
@OlRuss-ki8go Год назад
@@johndowe7003 I didn't install this but inside on new plate there is a spot that the original coil spring makes contact to new plate
@OlRuss-ki8go
@OlRuss-ki8go Год назад
I tried sending pic to your site
@johndowe7003
@johndowe7003 Год назад
@@OlRuss-ki8go I don't have a website.
@ryanvenner7920
@ryanvenner7920 4 года назад
Is the "half spark plug" part that screws into the top of the distributor and your coil wire connects to included with the Pertronix 1247XT kit? I don't see in in the picture of the kit, and it doesn't have a good parts breakdown. ai'm wondering if this item needs to be purchased in addition to the kit?
@johndowe7003
@johndowe7003 4 года назад
It comes in the kit
@johndowe7003
@johndowe7003 5 лет назад
Update on this kit, dont mount the round coil where i did (on the oil filter housing) , it will overheat it and make your tractor shut off. id suggest putting it on the starter or somewhere else where it wont get hot.
@robertmillsap7560
@robertmillsap7560 Год назад
You forgot the rotor.
@johndowe7003
@johndowe7003 Год назад
It's in there , I fixed the error off camera. Still in the tractor too. Hope it helped.👍
@thedailydee
@thedailydee 5 лет назад
Met you on the live. You are just starting out but trust me, you can go far pretty easy. Keep up the great work.
@johndowe7003
@johndowe7003 5 лет назад
hah its all good, i do it for my own entertainment, not really looking for financial gain haha
@tanksoldier9770
@tanksoldier9770 5 лет назад
How is that kit working out for you ? How much do they cost ?
@johndowe7003
@johndowe7003 5 лет назад
around 200$ the kit works out beautifully, tractor has more power and easier to start. my last set of points and condensor last only a few months before it got too weak to start. it runs way better and i was able to adjust the carb to flow more fuel and i can feel the difference in power. well worth the money. amzn.to/2EZSj8A thats the one i used.
@kitycat4618
@kitycat4618 4 года назад
Were did you get kit
@johndowe7003
@johndowe7003 4 года назад
link is in description
@leewhaley552
@leewhaley552 5 лет назад
Great video. Did you time it like you do with points ? How about resistors with the round coil ?
@johndowe7003
@johndowe7003 5 лет назад
i set the timing the same as points, so about halfways on the slider. the round coil i used had a 3ohm resistor built in but it kept overheating after running it long, so instead of wiring it direct to the battery its supposed to be wired into a ignition switch. i did buy another 3ohm resitor but i havent installed it yet. the wiring aint pretty but i left myself enough wire inase i needed some i could cut it off and use it in a pinch, so excuse my shitty wiring setup lol
@leewhaley552
@leewhaley552 5 лет назад
@@johndowe7003 thanks for your response. I'm trying to get my '49 running. A colony of ants invaded my coil and shorted it out. I think they came in through the vent hole on the distributor cap.
@johndowe7003
@johndowe7003 5 лет назад
@@leewhaley552 that'll do it to screw everything up. if you got any other questions feel free to ask. :D
@BNOOutdoors
@BNOOutdoors 5 лет назад
From the live!! Great video! Rang that bell
@johndowe7003
@johndowe7003 5 лет назад
thanks man
@GreenstreetRecyclingMan
@GreenstreetRecyclingMan 5 лет назад
Hello stopping over to show some love!
@SophiasSpace
@SophiasSpace 5 лет назад
Hey checking your channel out stopping by to support connected connect
@johndowe7003
@johndowe7003 5 лет назад
thanky you, ive done some tailoring but mostly fitting jeans.
@leonardwoodside6549
@leonardwoodside6549 4 года назад
Anybody notice he didn't show putting the rotor bug back on?
@johndowe7003
@johndowe7003 4 года назад
You're right I didn't show that, I forgot to put it on when I recorded it. I installed it off camera before it went in the tractor
@mikerakow9015
@mikerakow9015 3 года назад
@@johndowe7003 kind of an important step? as it will not work without it?
@OlRuss-ki8go
@OlRuss-ki8go Год назад
I caught it right away too !
@alarry31
@alarry31 8 месяцев назад
How did you set the timing
@deadcarnahans1932
@deadcarnahans1932 3 года назад
The video sucks. does not have same aspect ratio as my TV. Could not watch it.
@johndowe7003
@johndowe7003 3 года назад
sorry bub, try on your phone i suppose..
@deadcarnahans1932
@deadcarnahans1932 3 года назад
Don't watch TV on phone. Phone is for phone calls and text. My laptop screen is 13.5 x 7.5. Your video is exactly 4.312 wide I suppose next time you make video you can rotate your camera 90 degrees. Might make it fit screen here better.
@johndowe7003
@johndowe7003 3 года назад
@@deadcarnahans1932 yeah I figured . Didn't have a way to hold.my.phone at the Time, I got a new mic and phone holder now I just gotta make more videos 👍 . If I recall my.other vids aren't vertical o dunno which tho
Далее
COMMUNISM vs CAPITALISM: Who Made Better Power Tools?
24:39
Small Engine Fuel Filters
21:11
Просмотров 36 тыс.
Why Do LED Bulbs Fail? An Autopsy!
16:57
Просмотров 109 тыс.
I Made A Rotary Vane Engine Prototype
31:27
Просмотров 233 тыс.
6 to 12 Volt Conversion on a Ford 8N
11:04
Просмотров 159 тыс.
The 8N Project - 12 Volt Conversion Pt 1
21:30
Просмотров 6 тыс.