Excellent Video Jerome! Most other's don't mention disconnecting the battery, I'd hate to have a spark from a loose wire happen while that pump is out! AND you remembered to tell us to reconnect the battery. Nice. What other videos do you have I wonder...
Why anyone would drop a tank is beyond me. Unless for some reason you just could not remove the bed but seriously this is the only way to do it. So much easier, thanks for the good hints.
I'am Your Newest Subscriber Great Videos. I Wanta Get My 94 S10 Choptop Pickup Truck Running Again It Hasent Ran In 11 Years 2.2 Liter 5 Speed I Wanta Drive It Again
Great video ! Going to do mine this fall! The only thing I am going to do is use a blow dryer to heat the tubing! No open flames around that gas tank for me !
Cut a hole in the bed, 1000 times easier. I can get the measurements from my truck if you want. I cut a nice square hole on my bed. Then screwed the piece back in place.
thank you for taking tim e to do this jerome , i dont need a feul pump yet but its good to see how its done .......how long over all does it take to reinstall one counting , taking the bed off ? thanks , marcus in west texas !!!\
Thank you Jerome! I needed to help my son pull his fuel pump so he could send it in for a warranty replacement and your video showed me how to remove the fuel lines and lock ring.
Great job! Your video on replacing the S10 fuel pump is the best I have seen on the Tube. Your work - especially seeing that you do it all by yourself -- is every bit as good as some of the "professional" DIY videos. Thank you..
Thank for making this video. I have to do this today. Hope it goes well. Couple comments... bleed fuel pressure first. Blow crud from top to keep it from falling into tank. A new fuel pump was only $20 something dollars from eBay.
Great video Jerome. I have a 98 s-10 and did it the same way you did. Not to hard , all you need is a little courage to start the project and the rest just follows.
Im building courage. I do need dome muscles to aid in bed removal!!! Going under to see where bolts are to release. I called for estimate $500. For labor. What a RIP OFF.
how long did it take you to get that ring snapped in all the places i could not get my in all the way and it went in at a angle and could not get it straight
I would strongly recommend not using a lighter on the heatshrink, in this case I would say to use a soldering iron, a flameless source of heat. Other than that this was very informative.
Thank you sir for all the help... It really helped a lot! Unfortunately I'm still having problems after I installed the new pump. For some reason I have no power to the pump...... I cant hear the pump go on when I turn the key as I usually did. I'm currently diagnosing the problem.... Any way question for you sir... If you pause the video at 7:37 you will see the entire view of the rear of the truck.... What is that rectangular looking (small tank looking) part to the right of the main tank? ( where your pliers are sitting and a white paper).... I have the same thing however I want to replace all I can while I have the bed off. What is that part called?
Unos de los mejores videos explicativos . Supongo que no es primera vez que cambia una bomba y que al final le prendió la camioneta... Al final se transforma en una película de misterio
Is this the same as a 4.3 I have 96 v6 s10 the shop is telling me a thousand dollars and said they have to drop the tank and replace lines possibly. So screwed I work on vehicles often my truck won’t start it has spark is just won’t get gas
