What is id run in VFD? The purpose of the motor ID run is to allow the VFD to create a motor model in its memory that it can consult for % of nameplate torque and motor shaft speed.
dear sir i have abb drive 2.2 kw 3phase motor run position many times stop There is no error i change bush buttons relay with bas and also drive but still problems
@@bishantkumar12589 sir i am electronics engineer. I want to know from you whether I should change the ID card or solve the program problem in the software section? what advice do you think?
Sir, acs 800 drive me 99 group me motor data set kardia but jab id run kia to no motor data show karta he drive, kya problem ho sakta he thoda bataiye sir
Maximum current limit too low. Check settings of parameters 99.06 Motor nominal current and 30.17 Maximum current. Make sure that 30.17 > 99.06. Check that the drive is dimensioned correctly according to the motor.
Halo sir, Sir 22 kw abb ke vfd hi, usme vfd runing tim me vfd automatic output dena band kr deti hi. Fir 10 minutes ke bad chalne lagti hi. Na he koi alram aa rha hai, na he koi tripping indication. Out put voltage 412, 412,411 Feq 42 hz high set point. Ples help me sir
Well sorry about this, we hardly used laptop for program configuration in ABB ACS drives yet. So not having proper idea. With CDP/HMI we do program configuration
You can connect drive panel to USB to laptop. But this is normal panel. You can't do with this one. After connection you can Install drive composer pro or entry and can access full drive from it.
@@bishantkumar12589 Display fitting same hy but it's ACS 355 not ACS 550 , agr aap k pass ACS550 original panel display hy to aap ko difference pta chal jy ga
