Bulk Bag Filler for Spout Top type bulk bags and other Super Sack® and/or FIBC bulk bags types, BagPak 2100-ST, is constructed of heavy duty structural steel and an all stainless steel fill spout. The Spout Top bulk bag filler, has an air expanded bladder seals the bag spout to the filler during the fill cycle. Spout Top big bags are connected to an in-house dust collector or a simple cartridge filter, the entire fill cycle becomes a dust free operation. Watch our informative video about the BagPak 2100 Spout Top bulk bag filler.
For more information about this product: www.formpakinc...
For more information about FormPak, Inc. : formpakinc.com
Video Transcript:
The spout top BagPak filling frame is fabricated of one quarter inch thick, three and four inch square tube steel and features two six by four inch four pockets at the base for ease of moving into place. Also included is a dual pipe fill head with inflatable spout seal and dust port.
To use this device, first, place a pallet on the loader then thread all four bag lift loops onto the holder arms. The rule of thumb is to have the bag suspended so that the corners are approximately three to four inches up from the pallet, allowing the bag to stretch properly without any folds or leaning.
Adjustment is easily accomplished by removing the hitch pin while holding the arm, adjusting to desired height, then replacing the hitch and safety pins for each arm. Recheck for proper height. The fill head is adjusted the same way with the addition of the retention bolt used to level the fill head.
The bottom of the seal should be near the bottom of the support arms placing it four to six inches above the bag top. Once the bag is centered, the bag's fill spout can be pulled up and over the seal. Then the hand lever is actuated to inflate the seal inside the spout. The bag is now ready for filling.
Once the bag is full, release the pressure seal, and the spout can be pulled off the fill head and tied. The forklift can enter the pallet, lift slightly to relieve the pressure on the lift loops, and simply back out of the frame. This unit can be integrated with the spread base allowing the use of the pallet jack as well as many other options.
Please contact your FormPak representative for more information on this or other FormPak products.
27 авг 2024
