We have a leak on the pressure line for the power steering pump. It's only at the seal, so we are replacing the O-rings on both lines going to the pump. Check it out. #techreviewbyirdi #acura #honda
I wish I'd watched your video (and not done mine in dim lighting). I didn't realize the inlet was plastic and stripped the back threads. I didn't think to check torque, only went with feel on tightness with a socket. No leak so far, but any suggestions on dealing with the stripped threads since I can't actually tighten the bolt now? I can use loctite to keep it in place, but that's it. Again, the front one was tight but didn't break. Thanks if you have time to reply!
There's not much in pressure, use RED Loctite. It will withstand the heat by the engine. If you need to pull it out later, you can use an heater gun to warm it or hair dryer on hot to loosen the red loctite. I've done it before. Your good.
hi my name is anthony i have seat leon 2006 have eltic power stering red light has come on tryed every thing to remove stering is working fine no probleam what u think might be probleam thanks
thanks for replying but it eletric power not fluid it has tracion control asisted power sering power to sterring is working fine would it be falty abs rings
Mostly. I used a pump/air unit, off amazon. I used for a lot of fluid drawls. But I didn't need to take a lot out. Just a little. The rings are higher.
All you can do is laugh. He points to items while he has things (o-ring package) in the way so you can't see, Then he shows you items off screen. He also tells you to remove a bracket that is no longer there.