Thank you so much for sharing this video! I followed your instructions, disassembled my dishwasher pump, and found a piece of glass just like you mentioned, and now it's working perfectly again. Much appreciated 😊
Perfect video, you saved Christmas pal. Piece of broken glass was trapped in the pump, wouldn't drain, showed the i20 code. Found it when I opened up the pump. To anyone else, make sure you pay careful attention to pump positioning when you close it all up again so that it's properly sealed. I got that bit wrong initially and after a leak and an i10 error (water going into the machine and leaking straight back out again) I realised my mistake.
Thank you so much ❤ I had exactly the same issue - piece of glass. I've already ordered service technician but now I can cancel it. You saved my time and money
You saved our dw from the scrap heap! Obligato!! How ridiculous of Electrolux that they don't offer the solution themselves... guess they want money for tiny repairs? In Denmark it means nobody fixes anything, just throwing it away is cheaper
Korrekte Antwort: It's unfortunate that Electrolux doesn't provide solutions for repairs, leaving customers in a bind. Indeed, in Denmark, the throwaway culture seems to prevail due to the cost of repairs.
Thank you so much, toothpick hidden here 😊 fyi: make sure To tighten pump all around, I mistakenly only tightened 2/3 “sockets” and first run exploded with water as the pump flew Off 😂
Thanks lots! I opened and found a part of the string that had been used to tie the detached basket and dusts tangled in it were blocking the tube. I removed them, but then the error i5F of pump displayed a fault showed and didn't work. However, five hours later in the evening, I tried it and it worked! Perhaps it needed some time to reset? Anyway, I'm glad it worked. I'm truly grateful!
maaaan. tthanks a lot for sharing this. mine was clean inside. i will remove completely and open to see if the rotor is blocked. most likely i will need a new pump
I can’t detach the drain pump… it looks so easy in the video but I keep pushing really hard but it won’t come off… is there something holding it in place?
Heads up to everyone to clean deep inside the filter, particularly under the top part in all the grooves, even the slightest layer of gunk triggers an i20.
The problem can be also a blocked pipeline - the dishwasher itself is OK, but the pump pushes too hard through some blockage further in the pipeline. In this case, there is no i20 when draining the dishwasher into a bucket.
Hello, there was something in the filter below. But I think there is more inside the big filter below, can I open this somehow? Still have a code error i20
Hi There, a good video thank you! I could locate and check these two possible rasons. But they were not the cause at this time. Program reset and outlet hoses are checked as well. Symphton is, program stops in the middle, cleaning and reboot didn't help. Progran proceeds 1-2 mins each re-take, but repeats the e20. Originally there was 1-2 cm water in the bottom of the drain cup, like you had. But no new water is coming in with the reboot. what's next possible cause..?