Aluminum component manufacturing process for agricultural equipment. Old aluminum foundry in Japan. 

ジャガイモの収穫みたいw🥔

笑った

Me too😂

まあ、でもアルミって鉄鉱床のようなthe鉱物っていうより、赤土にしか見えないボーキサイトが原料になるからね。。 畑に見えなくもない（

固定おめでとうございますw

アジア圏のアルミキャスティング動画多いっすね笑僕もかなり見ています

一度見ちゃうとめっちゃ流れてくるやつ…

一連のパキスタンの動画は凄いね。

設備が違う、ツールが違う、服装が違う、いや全部違いますねw

ありがとう！！

Thank you !!! I was wondering what that was about

@@petert2481 not all masks, if they had a respirator of some kind it would help.

I suspect that these are low volume castings so economy of scale might limit investment in your sensible suggestions. Nice foundry to look at.

ได้กลิ่นไอ ระเหย จากการเทหล่อแบบอลูมิเนียมเลยครับ...ขอให้ตรวจวัดปริมาณ สารระเหยในเลือดทุกๆปีครับ...โดยเฉพาะ พิษสารตะกั่ว และโลหะหนักครับ..

Любой конвейер рассчитывается на конкретное изделие и крупный объем подопытных изделий такой тип работы как у них позволяет менять продукцию хоть каждый день без переделки производства - и на тот объем который они выпускают конвейер будет дорогим излишеством

thanks for the ideas. they should make it a lot easier. I also suspect that much of the reason why it is done on a floor is to prevent molten aluminum splashes. this can be made safer at hip level on assembly lines by using safety splash screens. i would also make the greensand compacting faster by introducing a third stage where you use an intermediary core specifically for the green sand compacting. though you would have to make many of the same parts for this to be worthwhile. I would also introduce a slower cooling phase using insulation and introduce a steel wire mesh skeleton inside parts to strengthen them. slower cooling will reduce stress fractures from thermal shock. i would keep the parts at 200 celsius for at least 24 hours afterwards, the molds should also be heated throroughly before casting. also when casting the part it should be slowly rotated to help fill voids (rotocasting). the furnace should have an autoskimmer that scrapes the surface entirely to remove the slag. though these ideas all apply only on large volume parts. small volume it becomes more diy as the setup takes too long.

This is a foundry. There is no need for technologies

it ain't boiling metal fumes, it is moisture from the sand mix, water vapor

ただの再利用で草

Sign plates