AMC gear box build Norton P11 

Fantastic video, just about to rebuild a commando MK 3 box which i assume is very similar very clear and much better than any manuals i have.my box came to me as a box of bits so most helpfull. Dave. (UK)

Excellent video, my gearbox bearing are worn out and I am rebuilding the box, Thanks

Thanks for the video. I really like how you show the orientation and placement of the gears/parts. Nice work!

keep putting this rebuild off, maybe this winter, thanks for commentary with alerts.

Thanks - helpful overview.

Just caught that bit up, good videos better than most, camera work is awesome

Just acquired a 68 g15cs. The previous owner only had the scoot for a short while. The kicker was stuck and he said it took a lot to push the kicker down. Now it springs up fine but grabs nothing on the kick down. Probably bad dogs. I'm sure the clutches and their plates are a bit stuck too.

great job

Very nice work young man! Thank you 🙏

Good video......only thing is before you put the outer cover on you have to put it in 2 nd gear then smear some grease on the roller to hold it in place put the spindle in the outer case then using the gear selector have the pawl on the second notch fron the top and slide the cover on , dont force it it should just slide on.If not take a break then come back to it and it will go together😃

Good video. Helpful.

Great video AJ! I really have to put mine together asap... has been way to long since I've took it apart, ur video will be of help for sure. I reckon M for Matchless ;-)

Liking the detailed shots and explanations. I did this whole job on my Norton Commando GB without removing it from the bike. For the two forward facing bolts holding the quadrant & "knuckle", I found the washers were not fully seating against the outside of the casing to make a good seal with the o-rings. So now I have a slow oil seep from both of those. Do you think I can remove the bolts and try fitting thicker o-rings without needing to remove anything else? Will the quadrant or knuckle drop out of position?

I find it interesting that the bushings are a "slip fit" in the bore of the gears. I understand the "running fit" on the shafts, but running fits on both the shaft and bore seems or is not common practice. Thoughts?

It's funny that the AMC gearbox rebuild videos never mention the oil seals in the outer cover or never show how the outer cover is refitted. This can be very tricky if you don't know the best way. I can only assume this is omitted rather than show the builder fiddling around for half an hour or so trying to do it?

Hi... Whats the best way to remove the 2 sleeve gear pinion bushes? Thanks 👍

did I miss something, or isn't the mainshaft nut missing