An Easy Way For $2 To Clear BMW "Passenger Restraint System" Error Code 

Learned from other videos to make sure the yellow wire is properly connected. Can lose connection from adjusting the seat, vacuuming, storing items under seat....

Where is this located on a 320d e90?

I’m wondering - OK you have fixed the error BUT is the airbag now going to work in case of an accident? Can you confirm please?

At the beginning of the video you cut the cord housing the resister from the system. You don't show how you reconnected this cord after repair.

Will this work on my 2006 530i? It's an e60

I was wondering if you could tell me where to buy the resistor I see soo many types on Amazon not sure which one is the correct one and many thanks

When you whant to show how we must do it on the pc make a clear video..but thx

What was the error code displayed in INPA?

Oitstanding video @AmericanLife365 . One question though, i have a 2008 bmw m6 and i cant find the cable to cut that you have in your video. Any idea where i should look ? 2:03 1:25

Hi I have 335i e90, does that take 2 ohm resistor aswell?

Thanks buddy I have 2 ohm and solder kit on way from Amazon already have reader. Hopefully my magic moment is like yours so my drivers seat starts working again and heat. Both are inop with passenger restraint fault!

Hello Charles my BMW X6 was up for sale and 2 men turned up to look at it 1 of them shook the drivers seat very bad say they have problems with the X6 range of drivers seats come loose it was a scam to get car cheaper

By this way does the airbag still working ? What did we cut off exactly

93CF passenger front right door airbag,doesn't says anything about battery

my dont work i i did exactly same thing 2om resistor and reset by inpa software but the light still on i dont know what i missed

Buy the B800 airbag and abs tool for BMW for 25$ & it'll erase it

Do you think this will solve error code: 0093f8 / ZK17 / Anchor Fitting driver?

I have the driver restraint system failure on a BMW 2013 X3, can this procedure work too? Thanks!!!!

Good job

What you did with the other end of the wire?

Does it needs to be exacly 2 ohms , cauze i have some 2k s

So what is the proper way to fix this?

Nobody saw that 6mpg 😎

Could I get your copy of inpa?

93f9?

Do you have an email address? I have the same issue on my 2016 428i ...the battery setup is different and would like to send picture to confirm the wire.

Did Muhammad Ali video this 😂😅😂 never seen anybody’s hand shake so much 🤣🤣🤣🤣

I cut mine for my bmw 525xi e60. Now it won’t start. Haven’t even got to add the 2ohm resistor part but tried to connect it back normally and now my car isn’t starting. Any suggestions? Should I add the 2ohm? I’m stressed out please help anyone. I get no crank or anything.