Arduino Tutorial 28- Understanding How to Use a Stepper Motor 

Incredibly simple explanations, which is very difficult to find on the internet these days. Well done.

Clear and concise. I set my stepper while watching your video and it worked 🙂, thank you for sharing

First video where is all explain step by step - thanks, it works well

THIS IS THE BEST VIDEO I'VE SEEN ABOUT HOW TO USE ANY ARDUINO DEVICE!!

Most of my parts were different but the tutorial was so good I could make it work. Thank you!

Thanks so much. This really helped me. I was activating the coils in the order 11, 10, 9, 8 from following other programs but it didn't work. Using your 8, 10, 9, 11 worked perfectly. Why does a sequential order not work?

Very well explained! Thank you, just wanna know if using that code, will the motor continue rotating endlessly ?

Whats the maximum speed and torque of this motor?

How can we control the stepper motor using RC remote

could you give me the code?

THANKS SO MUCH

please just add a link for the code It never works just showing us it'

How to do 90 degrees?

I tried with this but my stepper motor doesn't work , one more thing do I need to use the way you have used some pin on it

Could you please give me some advice? Is it possible for the engine to work even without a computer? I need it to keep spinning at 20 rpm. It is possible?

Help! My setup only runs clockwise and doesn't reverse! Everything is just as you wrote it, Paul. Also, I can run mine without the power supply.

please give the link or code

what to do if need the motor to rotate in constant rpm ?

Very nice! Thank you for creating such a helpful video. Your explanations were very clear for a beginner like me.

how to move it faster? Its a bit slow

great video

Hi, Love your video... I'm very new about this kind of programming... I have a question: is necessary to connect the ground and the 5v between Arduino and the driver?

is it possible to control the motor without the driver?

Hello dear bro, i followed this video step by step but when i send the code to my board, the board disconnect from the PC. notice that i have "Az-Delivery ESP32 Wroom" . i thought that the Stepper motor absorbs the energy. to solve this problem i brought an external enrgy source (Breadboard Power Supply), finally worked well but, i got the same problem that "Rajat parkkal" got, the motor don't rotate to the other way i mean the negative orientation. i'll be thankful to help us solving this problem. *Notice: i'm fresh in Arduino and i have no idea befor this is my first steps on this world.

Thx it works.

Doesn't the starting current affect the arduino power pin connected to the driver?? It should not tolerate more than 20mA

استاذ شاكر هي الحاجات دي بتتجاب منين؟؟

why does INT 1 and INT 2 stay on after the first command and only turn on after a reset?

when i put a negative number the motor is not turning the opposite direction whereas going in the same clockwise direction towards the angle. Is there a solution??

Can I change the rotation of the motor manually??

Plss can to tell me why the order is 8,10,9,11

ممكن تعطيني الكود لان كل ما اكتبه يطلع غلط انا سويت نفسك بالضبط

Your Gode erro from myStepper ! Tell me please

Thank you🙂

Sir please make a more video one motor 180 degree rotation after stop after number 2nd motor run 3 round after stop after 3rd rotation 4 pound after 1st motor rotation reverse 180 degree

It doesn't work

can u teach how to do stepper motor analog rpm gauge diagram and thank you